This series contains the event mux router support present in TI's K3
platforms. The event mux router are of 2 types
1) gpio-mux router
2) timesync router

In normal scenarios, GPIO signals are received by CPU via GIC, but the
gpio mux router routes the incoming GPIO signal to BCDMA(Block copy
DMA) which the DMA upon receiving uses as HW triger to perform a single
block transfer or as configured.

Time sync router achieves the same but for the time synchronization based
events.

This driver supports both the routers but this patch series adds support
only for GPIO-mux router.

Rahul Sharma (2):
  dt-bindings: mux-controller: ti: add binding for event mux router
  mux-controller: ti: add driver for event mux router

 .../mux/ti,am62l-event-mux-router.yaml        |  79 ++++++
 drivers/mux/Kconfig                           |  15 ++
 drivers/mux/Makefile                          |   2 +
 drivers/mux/ti-k3-event-mux.c                 | 235 ++++++++++++++++++
 4 files changed, 331 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mux/ti,am62l-event-mux-router.yaml
 create mode 100644 drivers/mux/ti-k3-event-mux.c

-- 
2.34.1