This patchset adds support for the PWM controller found on the
Raspberry Pi RP1 southbridge. This is necessary to operate the
cooling fan connected to one of the PWM channels.

The tachometer pin for the fan speed is managed by the firmware 
running on the RP1's M-core. It uses the PHASE2 register
to report the RPM, which is then exported by this driver via
syscon registers. A subsequent patch will add a new device
and driver to read the RPM and export this value via hwmon.
 
Subsequent patches will also add the CPU thermal zone, which
acts as a consumer of the PWM device.

Best regards,
Andrea

CHANGES in V7:

- _tohw(): use *wfhw = (typeof(*wfhw)){...} to initialize the
  structure in the disable case 
- _tohw(): fixed the offset_ticks calculation
- _fromhw(): fixed a rounding error in the duty_offset_ns calculation
- _write_waveform(): dropped the goto in favor of return in diasble
  channel exit path
- _read_waveform(): use *wfhw = (typeof(*wfhw)){...} to initialize
  the structure in the disable case
- dropped rp1_pwm_remove() since this driver depends on syscon
  and cannot be removed/unbound (added a comment to explain that)

Naushir Patuck (2):
  dt-bindings: pwm: Add Raspberry Pi RP1 PWM controller
  pwm: rp1: Add RP1 PWM controller driver

Stanimir Varbanov (1):
  arm64: dts: broadcom: rpi-5: Add RP1 PWM node

 .../bindings/pwm/raspberrypi,rp1-pwm.yaml     |  66 +++
 .../boot/dts/broadcom/bcm2712-rpi-5-b.dts     |  12 +
 arch/arm64/boot/dts/broadcom/rp1-common.dtsi  |   9 +
 drivers/pwm/Kconfig                           |   9 +
 drivers/pwm/Makefile                          |   1 +
 drivers/pwm/pwm-rp1.c                         | 428 ++++++++++++++++++
 6 files changed, 525 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/raspberrypi,rp1-pwm.yaml
 create mode 100644 drivers/pwm/pwm-rp1.c

-- 
2.35.3