On standalone switch ICs the link parameters of the CPU port need to
be setup just like user ports. The destinction in the driver to not
carry out link parameter setup for the CPU port does make sense for
in-SoC switches on which the CPU port is internally connected to the
SoC's Ethernet MAC.
Set link parameters also for the CPU port unless it is an internal
interface.

Signed-off-by: Daniel Golle <daniel@makrotopia.org>
---
 drivers/net/dsa/lantiq/lantiq_gswip_common.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/dsa/lantiq/lantiq_gswip_common.c b/drivers/net/dsa/lantiq/lantiq_gswip_common.c
index 00d4aff96f12..7ea5f26f3899 100644
--- a/drivers/net/dsa/lantiq/lantiq_gswip_common.c
+++ b/drivers/net/dsa/lantiq/lantiq_gswip_common.c
@@ -1459,7 +1459,7 @@ static void gswip_phylink_mac_link_up(struct phylink_config *config,
 	struct gswip_priv *priv = dp->ds->priv;
 	int port = dp->index;
 
-	if (!dsa_port_is_cpu(dp)) {
+	if (!dsa_port_is_cpu(dp) || interface != PHY_INTERFACE_MODE_INTERNAL) {
 		gswip_port_set_link(priv, port, true);
 		gswip_port_set_speed(priv, port, speed, interface);
 		gswip_port_set_duplex(priv, port, duplex);
-- 
2.51.0