GPIO IRQ setup can fail either because an invalid IRQ was passed as a
parameter, or because the GPIO controller does not support interrupts.
Neither is severe enough to stop the whole probe; simply disable IRQ
support in the GPIO resource when setup fails.
Signed-off-by: Matthias Schiffer <matthias.schiffer@ew.tq-group.com>
---
v2: no changes (was patch 3/4)
v3: replace IRQ 0 resource with an empty placeholder to simplify error handling
v4: no changes
drivers/mfd/tqmx86.c | 20 ++++++++------------
1 file changed, 8 insertions(+), 12 deletions(-)
diff --git a/drivers/mfd/tqmx86.c b/drivers/mfd/tqmx86.c
index 8aa448a67c9a5..e444fcd2a3e9d 100644
--- a/drivers/mfd/tqmx86.c
+++ b/drivers/mfd/tqmx86.c
@@ -68,12 +68,12 @@ static const struct resource tqmx_watchdog_resources[] = {
DEFINE_RES_IO(TQMX86_IOBASE_WATCHDOG, TQMX86_IOSIZE_WATCHDOG),
};
-/*
- * The IRQ resource must be first, since it is updated with the
- * configured IRQ in the probe function.
- */
static struct resource tqmx_gpio_resources[] = {
- DEFINE_RES_IRQ(0),
+ /*
+ * Placeholder for IRQ resource - must come first to be filled in by the
+ * probe function.
+ */
+ {},
DEFINE_RES_IO(TQMX86_IOBASE_GPIO, TQMX86_IOSIZE_GPIO),
};
@@ -255,13 +255,9 @@ static int tqmx86_probe(struct platform_device *pdev)
if (gpio_irq) {
err = tqmx86_setup_irq(dev, "GPIO", gpio_irq, io_base,
TQMX86_REG_IO_EXT_INT_GPIO_SHIFT);
- if (err)
- return err;
-
- /* Assumes the IRQ resource is first. */
- tqmx_gpio_resources[0].start = gpio_irq;
- } else {
- tqmx_gpio_resources[0].flags = 0;
+ if (!err)
+ /* Assumes the IRQ resource placeholder is first */
+ tqmx_gpio_resources[0] = DEFINE_RES_IRQ(gpio_irq);
}
ocores_platform_data.clock_khz = tqmx86_board_id_to_clk_rate(dev, board_id);
--
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
https://www.tq-group.com/