GPIO IRQ setup can fail either because an invalid IRQ was passed as a
parameter, or because the GPIO controller does not support interrupts.
Neither is severe enough to stop the whole probe; simply disable IRQ
support in the GPIO resource when setup fails.

Signed-off-by: Matthias Schiffer <matthias.schiffer@ew.tq-group.com>
---
 drivers/mfd/tqmx86.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/mfd/tqmx86.c b/drivers/mfd/tqmx86.c
index 2a4ce114d5905..cf27497245322 100644
--- a/drivers/mfd/tqmx86.c
+++ b/drivers/mfd/tqmx86.c
@@ -259,13 +259,14 @@ static int tqmx86_probe(struct platform_device *pdev)
 		err = tqmx86_setup_irq(dev, "GPIO", gpio_irq, io_base,
 				       TQMX86_REG_IO_EXT_INT_GPIO_SHIFT);
 		if (err)
-			return err;
+			gpio_irq = 0;
+	}
 
+	if (gpio_irq)
 		/* Assumes the IRQ resource is first. */
 		tqmx_gpio_resources[0].start = gpio_irq;
-	} else {
+	else
 		tqmx_gpio_resources[0].flags = 0;
-	}
 
 	ocores_platform_data.clock_khz = tqmx86_board_id_to_clk_rate(dev, board_id);
 
-- 
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
https://www.tq-group.com/