From: David Heidelberg <david@ixit.cz>

System suspend powers the controller off and resume powers it back on,
but the resume path enables the interrupt before s6sy761_power_on()
checks the boot. The firmware raises its boot-complete event on the
interrupt line, the threaded handler consumes it, s6sy761_power_on()
then reads an empty event and resume fails with -ENODEV, skipping the
touch function setup:

  s6sy761 2-0048: PM: dpm_run_callback(): s6sy761_resume [s6sy761] returns -19

Power the chip on first and only then unmask the interrupt. Once resume
completes the boot handshake the chip comes back with sensing off, as
at probe where input_open() turns it on, so the touchscreen stays dead
after resume. Send SENSE_ON again when the input device is open.

Tested on a Pixel 3 XL over several s2idle cycles: resume succeeds and
the touch function and sense status match the pre-suspend state.

Assisted-by: LLM
Cc: stable@vger.kernel.org
Fixes: 0145a7141e59 ("Input: add support for the Samsung S6SY761 touchscreen")
Signed-off-by: David Heidelberg <david@ixit.cz>
---
 drivers/input/touchscreen/s6sy761.c | 11 ++++++++++-
 1 file changed, 10 insertions(+), 1 deletion(-)

diff --git a/drivers/input/touchscreen/s6sy761.c b/drivers/input/touchscreen/s6sy761.c
index 0f24a9b730635..c52c45a7d1029 100644
--- a/drivers/input/touchscreen/s6sy761.c
+++ b/drivers/input/touchscreen/s6sy761.c
@@ -495,20 +495,29 @@ static int s6sy761_suspend(struct device *dev)
 	s6sy761_power_off(sdata);
 
 	return 0;
 }
 
 static int s6sy761_resume(struct device *dev)
 {
 	struct s6sy761_data *sdata = dev_get_drvdata(dev);
+	int err;
 
+	err = s6sy761_power_on(sdata);
 	enable_irq(sdata->client->irq);
+	if (err)
+		return err;
 
-	return s6sy761_power_on(sdata);
+	guard(mutex)(&sdata->input->mutex);
+
+	if (!input_device_enabled(sdata->input))
+		return 0;
+
+	return i2c_smbus_write_byte(sdata->client, S6SY761_SENSE_ON);
 }
 
 static const struct dev_pm_ops s6sy761_pm_ops = {
 	SYSTEM_SLEEP_PM_OPS(s6sy761_suspend, s6sy761_resume)
 	RUNTIME_PM_OPS(s6sy761_runtime_suspend, s6sy761_runtime_resume, NULL)
 };
 
 #ifdef CONFIG_OF

---
base-commit: 7079a12d7506b07fb53b54a664bfad5fa9b16d70
change-id: 20260923-s6sy761-suspend-24674b0857ba

Best regards,
--  
David Heidelberg <david@ixit.cz>