net/ipv6/ioam6_iptunnel.c | 8 ++++++-- net/ipv6/rpl_iptunnel.c | 4 +++- net/ipv6/seg6_iptunnel.c | 12 +++++++++--- 3 files changed, 18 insertions(+), 6 deletions(-)
The seg6, ioam6 and rpl lwtunnels all grow the headroom with
skb_cow_head(), push their new headers into it, and then rebuild the mac
header below them with skb_mac_header_rebuild(). The headroom left
after the push has to be at least skb->mac_len for that rebuild, but the
requests ask for the pushed length plus dst_dev_overhead(), which leaves
LL_RESERVED_SPACE() of the egress device, 16 bytes for plain Ethernet.
Where the mac header is longer than that, as it is on ingress through a
VLAN device with reorder_hdr off, the rebuild runs out of room:
skb_set_mac_header(skb, -skb->mac_len) computes a negative offset,
stores it unchecked in the u16 skb->mac_header, and the memmove that
follows writes skb->mac_len bytes about 64 KB past skb->head.
Forwarding plain ping6 traffic through such a device reproduces it on
all five seg6 encapsulation modes and on the rpl and ioam6 inline paths;
skb->mac_header comes back as 65534 on a 704-byte head.
Ask for whichever of the two is larger. These requests carried
skb->mac_len until the egress overhead took its place rather than
joining it.
Fixes: 40475b63761a ("net: ipv6: seg6_iptunnel: mitigate 2-realloc issue")
Fixes: dce525185bc9 ("net: ipv6: ioam6_iptunnel: mitigate 2-realloc issue")
Fixes: 985ec6f5e623 ("net: ipv6: rpl_iptunnel: mitigate 2-realloc issue")
Assisted-by: LLM
Signed-off-by: Yuya Kusakabe <yuya.kusakabe@gmail.com>
Reviewed-by: Justin Iurman <justin.iurman@gmail.com>
---
Changes in v2:
- Use max_t(unsigned int, ...) rather than max() [Justin]
- Make the same change in ioam6_iptunnel and rpl_iptunnel [Justin]
- Reproduce and verify the fix on those two as well: unpatched, rpl
underflows in 12 of 16 probed configurations and ioam6 in 3 of 13,
both reaching about 64 KB past a 320-byte head; patched, neither
underflows in 18
- Rewrap the requests so they no longer exceed 80 columns
- Retitle for net: ipv6, now that the change spans three files
- Link to v1: https://lore.kernel.org/r/20260917-seg6-maclen-headroom-v1-1-02ccec50f096@gmail.com
---
net/ipv6/ioam6_iptunnel.c | 8 ++++++--
net/ipv6/rpl_iptunnel.c | 4 +++-
net/ipv6/seg6_iptunnel.c | 12 +++++++++---
3 files changed, 18 insertions(+), 6 deletions(-)
diff --git a/net/ipv6/ioam6_iptunnel.c b/net/ipv6/ioam6_iptunnel.c
index cfb2c41634a0..4fc745f78eaf 100644
--- a/net/ipv6/ioam6_iptunnel.c
+++ b/net/ipv6/ioam6_iptunnel.c
@@ -262,7 +262,9 @@ static int ioam6_do_inline(struct net *net, struct sk_buff *skb,
hdrlen = (tuninfo->eh.hdrlen + 1) << 3;
- err = skb_cow_head(skb, hdrlen + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, hdrlen +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err))
return err;
@@ -303,7 +305,9 @@ static int ioam6_do_encap(struct net *net, struct sk_buff *skb,
hdrlen = (tuninfo->eh.hdrlen + 1) << 3;
len = sizeof(*hdr) + hdrlen;
- err = skb_cow_head(skb, len + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, len +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err))
return err;
diff --git a/net/ipv6/rpl_iptunnel.c b/net/ipv6/rpl_iptunnel.c
index 4e10adcd70e8..69d5c7b61e36 100644
--- a/net/ipv6/rpl_iptunnel.c
+++ b/net/ipv6/rpl_iptunnel.c
@@ -154,7 +154,9 @@ static int rpl_do_srh_inline(struct sk_buff *skb, const struct rpl_lwt *rlwt,
hdrlen = ((csrh->hdrlen + 1) << 3);
- err = skb_cow_head(skb, hdrlen + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, hdrlen +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err)) {
kfree(buf);
return err;
diff --git a/net/ipv6/seg6_iptunnel.c b/net/ipv6/seg6_iptunnel.c
index 61c6a27bf202..ed0e8f3ef1f1 100644
--- a/net/ipv6/seg6_iptunnel.c
+++ b/net/ipv6/seg6_iptunnel.c
@@ -153,7 +153,9 @@ static int __seg6_do_srh_encap(struct sk_buff *skb, struct ipv6_sr_hdr *osrh,
hdrlen = (osrh->hdrlen + 1) << 3;
tot_len = hdrlen + sizeof(*hdr);
- err = skb_cow_head(skb, tot_len + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, tot_len +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err))
return err;
@@ -255,7 +257,9 @@ static int seg6_do_srh_encap_red(struct sk_buff *skb,
tot_len = red_hdrlen + sizeof(struct ipv6hdr);
- err = skb_cow_head(skb, tot_len + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, tot_len +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err))
return err;
@@ -351,7 +355,9 @@ static int __seg6_do_srh_inline(struct sk_buff *skb, struct ipv6_sr_hdr *osrh,
hdrlen = (osrh->hdrlen + 1) << 3;
- err = skb_cow_head(skb, hdrlen + dst_dev_overhead(cache_dst, skb));
+ err = skb_cow_head(skb, hdrlen +
+ max_t(unsigned int, skb->mac_len,
+ dst_dev_overhead(cache_dst, skb)));
if (unlikely(err))
return err;
---
base-commit: 9a1599eeb8d18a2113e4cabcbd3bec5a8377dbed
change-id: 20260917-seg6-maclen-headroom-53a339c17dac
Best regards,
--
Yuya Kusakabe <yuya.kusakabe@gmail.com>
On 9/18/26 03:28, Yuya Kusakabe wrote:
> The seg6, ioam6 and rpl lwtunnels all grow the headroom with
> skb_cow_head(), push their new headers into it, and then rebuild the mac
> header below them with skb_mac_header_rebuild(). The headroom left
> after the push has to be at least skb->mac_len for that rebuild, but the
> requests ask for the pushed length plus dst_dev_overhead(), which leaves
> LL_RESERVED_SPACE() of the egress device, 16 bytes for plain Ethernet.
>
> Where the mac header is longer than that, as it is on ingress through a
> VLAN device with reorder_hdr off, the rebuild runs out of room:
> skb_set_mac_header(skb, -skb->mac_len) computes a negative offset,
> stores it unchecked in the u16 skb->mac_header, and the memmove that
> follows writes skb->mac_len bytes about 64 KB past skb->head.
> Forwarding plain ping6 traffic through such a device reproduces it on
> all five seg6 encapsulation modes and on the rpl and ioam6 inline paths;
> skb->mac_header comes back as 65534 on a 704-byte head.
>
> Ask for whichever of the two is larger. These requests carried
> skb->mac_len until the egress overhead took its place rather than
> joining it.
>
> Fixes: 40475b63761a ("net: ipv6: seg6_iptunnel: mitigate 2-realloc issue")
> Fixes: dce525185bc9 ("net: ipv6: ioam6_iptunnel: mitigate 2-realloc issue")
> Fixes: 985ec6f5e623 ("net: ipv6: rpl_iptunnel: mitigate 2-realloc issue")
> Assisted-by: LLM
> Signed-off-by: Yuya Kusakabe <yuya.kusakabe@gmail.com>
> Reviewed-by: Justin Iurman <justin.iurman@gmail.com>
> ---
> Changes in v2:
> - Use max_t(unsigned int, ...) rather than max() [Justin]
> - Make the same change in ioam6_iptunnel and rpl_iptunnel [Justin]
> - Reproduce and verify the fix on those two as well: unpatched, rpl
> underflows in 12 of 16 probed configurations and ioam6 in 3 of 13,
> both reaching about 64 KB past a 320-byte head; patched, neither
> underflows in 18
> - Rewrap the requests so they no longer exceed 80 columns
> - Retitle for net: ipv6, now that the change spans three files
> - Link to v1: https://lore.kernel.org/r/20260917-seg6-maclen-headroom-v1-1-02ccec50f096@gmail.com
> ---
> net/ipv6/ioam6_iptunnel.c | 8 ++++++--
> net/ipv6/rpl_iptunnel.c | 4 +++-
> net/ipv6/seg6_iptunnel.c | 12 +++++++++---
> 3 files changed, 18 insertions(+), 6 deletions(-)
>
> diff --git a/net/ipv6/ioam6_iptunnel.c b/net/ipv6/ioam6_iptunnel.c
> index cfb2c41634a0..4fc745f78eaf 100644
> --- a/net/ipv6/ioam6_iptunnel.c
> +++ b/net/ipv6/ioam6_iptunnel.c
> @@ -262,7 +262,9 @@ static int ioam6_do_inline(struct net *net, struct sk_buff *skb,
>
> hdrlen = (tuninfo->eh.hdrlen + 1) << 3;
>
> - err = skb_cow_head(skb, hdrlen + dst_dev_overhead(cache_dst, skb));
> + err = skb_cow_head(skb, hdrlen +
> + max_t(unsigned int, skb->mac_len,
> + dst_dev_overhead(cache_dst, skb)));
The above snipped is repeated 6 times verbatim: it's calling loudly for
some deduplication.
Since all the existing dst_dev_overhead() users are touched here, I
suggest moving the max() computation inside dst_dev_overhead().
/P
On 9/22/26 15:46, Paolo Abeni wrote: > Since all the existing dst_dev_overhead() users are touched here, I > suggest moving the max() computation inside dst_dev_overhead(). Thanks, that is what v3 does, posted before this mail: https://lore.kernel.org/r/20260922-seg6-maclen-headroom-v3-1-7b2f982ef79d@gmail.com
© 2016 - 2026 Red Hat, Inc.