Three fixes for the Moxa PCIe serial driver, found by reading the code
that was split out of 8250_pci.c and extended during this cycle.  The
driver is not in mainline yet, so the series is against tty-next.

Patch 1 fixes a NULL pointer dereference during probe on the boards
without RS232 support: the serial core calls ->rs485_config() from
within serial8250_register_8250_port(), which happens before
pci_set_drvdata() has published the board.

Patch 2 makes the probe fail when a port cannot be registered.  Today it
returns success, and removal then unregisters ports that were never
registered: line 0 for the entries the loop did not reach, and a
negative line number for the one that failed.

Patch 3 stops set_termios() from dereferencing port->state->port.tty,
which is NULL when the serial core sets the line up for a console or for
kgdboc.

I have no Moxa board here, so the series is compile-tested only: W=1
allmodconfig build of drivers/tty/serial/8250/ and checkpatch --strict,
both clean.

Linmao Li (3):
  serial: 8250_mxpcie: set the driver data before registering ports
  serial: 8250_mxpcie: fail the probe when a port cannot be registered
  serial: 8250_mxpcie: take the line settings from the new termios

 drivers/tty/serial/8250/8250_mxpcie.c | 34 ++++++++++++++++-----------
 1 file changed, 20 insertions(+), 14 deletions(-)


base-commit: 8b0b29fdcb47907ae0296b8fe829e918e05e300f
-- 
2.25.1