From: Biju Das <biju.das.jz@bp.renesas.com>

This series extends the RZ/G2L GPT PWM driver with RZ/G3E SoC support.

The RZ/G3E GPT has a number of hardware differences compared to RZ/G2L:
it exposes 16 channels (across two GPT instances of 8 channels each),
uses a 4-bit GTCR prescaler field (versus 3-bit on RZ/G2L), and has a
discontinuous prescale sequence with powers-of-2 scaling rather than the
continuous powers-of-4 sequence on RZ/G2L. It also has additional clocks
and resets (bus clock and rst_s).

To accommodate these differences cleanly the series proceeds as follows:

Patches 1-2 add DT binding documentation for the renesas,poegs property
(allowing GPT channels to be linked with POEG for output-disable) and
implement the corresponding driver support. This configures GTINTAD to
route output-disable requests to the correct POEG group and sets GTIOR
to tri-state both output pins on an output-disable event.

Patch 3 is a small cleanup removing an unused parameter from
rzg2l_gpt_calculate_prescale().

Patch 4 migrates the driver from the legacy .get_state/.apply ops to
the new waveform callback interface, introducing struct
rzg2l_gpt_waveform to hold the hardware configuration (gtpr, gtccr,
prescale) for a single channel.

Patches 5-7 introduce struct rzg2l_gpt_info to capture SoC-specific
hardware differences, adding fields for the GTCR prescaler mask
(gtcr_tpcs), the prescaler multiplier (prescale_mult), and a
calculate_prescale() function pointer. This cleanly abstracts the
per-SoC prescaler logic needed for RZ/G3E.

Patch 8 adds DT binding documentation for the RZ/G3E GPT
(renesas,r9a09g047-gpt), covering its 16-channel layout, 64 interrupts,
dual clocks and dual resets.

Patch 9 adds the RZ/G3E driver support itself, wiring up the new
rzg3e_data match entry with its own prescale calculation, prescaler
field mask, and prescale multiplier.

v4->v5:
 * Merged GPT linking POEG patch series here.
 * Dropped suspend/resume patch; will be added later.
 * Updated commit description for patches #2, #4, #5, and #6.
 * Replaced return type of rzg2l_gpt_poeg_init() from void to int and
   probe() check this return value.
 * Added more error checks in rzg2l_gpt_poeg_init().
 * Added a patch to drop the unused rzg2l_gpt_chip parameter from
   rzg2l_gpt_calculate_prescale().
 * Updated rzg2l_gpt_round_waveform_tohw() to initialize gtccr when the
   period of the second channel is smaller.
 * Replaced period_ticks with RZG2L_MAX_TICKS for the duty_ticks maximum
   value check in rzg2l_gpt_round_waveform_tohw().
v3->v4:
 * Added wave form callback conversion back to this patch series.
 * Updated rzg2l_gpt_is_ch_enabled() fit into 80-character limit for
   consistency with other functions.
 * Dropped field_{get,prep} as mainline now support it.
 * Updated commit description for patch#3
 * Retained RZG2L_GTCR_TPCS bit definitons
 * Replaced gtcr_tpcs_mask->gtcr_tpcs
 * Updated commit header and description for patch#4
 * Renamed prescale_pow_of_two_mult_factor->prescale_mult
 * Added RZG3E_GTCR_TPCS bit definition for RZ/G3E and added to
   rzg3e_data.
 * Added error checks on suspend() and device set to operational state
   on failure().
 * Added Rb tag from Geert for SoC dtsi.
 * Added SW_GPIO9_CAN1_STB check to gpt0 node.
v2->v3:
 * Added Rb tag from Rob for bindings patch
 * Dropped wave form callback conversion from this patch series as
   it is covered in another series[1]
 * Added suspend/resume support.
v1->v2:
 * Created separate document for RZ/G3E GPT.
 * Updated commit header and description for binding patch.
 * Added waveform callback conversion to this series.
 * Collected tag.
 * Added link to hardware manual
 * Updated limitation section in driver patch.

Biju Das (9):
  dt-bindings: pwm: rzg2l-gpt: Document renesas,poegs property
  pwm: rzg2l-gpt: Add support for gpt linking with poeg
  pwm: rzg2l-gpt: Drop unused rzg2l_gpt_chip parameter from
    rzg2l_gpt_calculate_prescale()
  pwm: rzg2l-gpt: Convert to waveform callbacks
  pwm: rzg2l-gpt: Add info variable to struct rzg2l_gpt_chip
  pwm: rzg2l-gpt: Add prescale_mult variable to struct rzg2l_gpt_info
  pwm: rzg2l-gpt: Add calculate_prescale() callback to struct
    rzg2l_gpt_info
  dt-bindings: pwm: Document RZ/G3E GPT support
  pwm: rzg2l-gpt: Add RZ/G3E support

 .../bindings/pwm/renesas,rzg2l-gpt.yaml       |  23 ++
 .../bindings/pwm/renesas,rzg3e-gpt.yaml       | 323 ++++++++++++++++
 drivers/pwm/pwm-rzg2l-gpt.c                   | 360 ++++++++++++++----
 3 files changed, 626 insertions(+), 80 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/pwm/renesas,rzg3e-gpt.yaml

-- 
2.43.0