From: Dennis Gilmore <dennis@ausil.us>
This series adds initial support for Orange Pi 5 Pro. The PCIe attached network
driver(dwmac-motorcomm) was just added.
The series was tested against Linux 7.0-rc7
Please take a look.
Thank you,
Dennis Gilmore
Changes in v6:
- Move the shared configs for the Orange Pi 5 and Orange Pi 5b from each
devices dts to a shared rk3588s-orangepi-5-5b.dtsi to avoid duplication
- Remove empty ports subnodeis from typea_con
- Move i2s2m1_mclk pinctrl from &i2s2 to the es8388 codec node
- Add dp-con, dp0_out, dp0_in, and vp1 nodes, plus the vcc3v3_dp regulator
in order to get the second HDMI port working via its transparent
LT8711UXD DP to HDMI bridge
- link to v5 https://lore.kernel.org/linux-devicetree/20260401010707.2584962-1-dennis@ausil.us/
Changes in v5:
- define a connector node for Type-A port, and list the regulator as its VBUS supply explicitly.
- Requires https://lore.kernel.org/all/20260217-typea-vbus-v1-1-657b4e55a4c2@flipper.net/
- link to v4 https://lore.kernel.org/linux-devicetree/20260310031002.3921234-1-dennis@ausil.us/
Changes in v4:
- rename vcc3v3_pcie20 copied from rk3588s-orangepi-5.dts to vcc3v3_phy1 to match the schematic
- use vcc_3v3_s3 as the supply not vcc5v0_sys for PCIe
- remove the definition for vcc3v3_pcie_m2 as it does not really exist
as a regulator
- link to v3 https://lore.kernel.org/linux-devicetree/20260306024634.239614-1-dennis@ausil.us/
Changes in v3:
- moved leds from gpio-leds to pwm-leds
- remove disable-wp from sdio
- rename vcc3v3_pcie_eth regulator to vcc3v3_pcie_m2 to reflect the
purppose
- actually clean up the delete lines and comments missed in v2
- link to v2 https://lore.kernel.org/linux-devicetree/20260304025521.210377-1-dennis@ausil.us/
Changes in v2:
- moved items not shared by orangepi 5/5b/5 Pro from dtsi to 5 and 5b
dts files
- removed all the comments and deleted properties from 5 Pro dts
- Link to v1 https://lore.kernel.org/linux-devicetree/20260228205418.2944620-1-dennis@ausil.us/
Dennis Gilmore (3):
dt-bindings: arm: rockchip: Add Orange Pi 5 Pro
arm64: dts: rockchip: refactor items from Orange Pi 5/b to prep for
Pro
arm64: dts: rockchip: Add Orange Pi 5 Pro board support
.../devicetree/bindings/arm/rockchip.yaml | 1 +
.../display/rockchip/rockchip,dw-dp.yaml | 7 +
arch/arm64/boot/dts/rockchip/Makefile | 1 +
.../dts/rockchip/rk3588s-orangepi-5-5b.dtsi | 192 ++++++++++
.../dts/rockchip/rk3588s-orangepi-5-pro.dts | 352 ++++++++++++++++++
.../boot/dts/rockchip/rk3588s-orangepi-5.dts | 6 +-
.../boot/dts/rockchip/rk3588s-orangepi-5.dtsi | 198 +---------
.../boot/dts/rockchip/rk3588s-orangepi-5b.dts | 2 +-
drivers/gpu/drm/bridge/synopsys/dw-dp.c | 12 +
9 files changed, 582 insertions(+), 189 deletions(-)
create mode 100644 arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5-5b.dtsi
create mode 100644 arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5-pro.dts
--
2.53.0