In GPI mode, the I2C GENI driver programs an extra TX DMA transfer
descriptor (TRE) on the TX channel when handling a single read message.
This results in an unintended write phase being issued on the I2C bus,
even though a read transaction does not require any TX data.

For a single-byte read, the correct hardware sequence consists of the
CONFIG and GO commands followed by a single RX DMA TRE. Programming an
additional TX DMA TRE is redundant, causes unnecessary DMA buffer
mapping on the TX channel, and may lead to incorrect bus behavior.

Update the transfer logic to avoid programming a TX DMA TRE for single
read messages in GPI mode.

Co-developed-by: Maramaina Naresh <naresh.maramaina@oss.qualcomm.com>
Signed-off-by: Maramaina Naresh <naresh.maramaina@oss.qualcomm.com>
Signed-off-by: Aniket Randive <aniket.randive@oss.qualcomm.com>
---

Changes in v2:
  - Updated the commit message.

 drivers/i2c/busses/i2c-qcom-geni.c | 18 +++++++++++++-----
 1 file changed, 13 insertions(+), 5 deletions(-)

diff --git a/drivers/i2c/busses/i2c-qcom-geni.c b/drivers/i2c/busses/i2c-qcom-geni.c
index a4acb78fafb6..2706309bbebb 100644
--- a/drivers/i2c/busses/i2c-qcom-geni.c
+++ b/drivers/i2c/busses/i2c-qcom-geni.c
@@ -625,8 +625,8 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[],
 {
 	struct gpi_i2c_config *peripheral;
 	unsigned int flags;
-	void *dma_buf;
-	dma_addr_t addr;
+	void *dma_buf = NULL;
+	dma_addr_t addr = 0;
 	enum dma_data_direction map_dirn;
 	enum dma_transfer_direction dma_dirn;
 	struct dma_async_tx_descriptor *desc;
@@ -639,6 +639,11 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[],
 	gi2c_gpi_xfer = &gi2c->i2c_multi_desc_config;
 	msg_idx = gi2c_gpi_xfer->msg_idx_cnt;
 
+	if (op == I2C_WRITE && msgs[msg_idx].flags & I2C_M_RD) {
+		peripheral->multi_msg = true;
+		goto skip_dma;
+	}
+
 	dma_buf = i2c_get_dma_safe_msg_buf(&msgs[msg_idx], 1);
 	if (!dma_buf) {
 		ret = -ENOMEM;
@@ -668,6 +673,7 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[],
 		flags = DMA_PREP_INTERRUPT | DMA_CTRL_ACK;
 	}
 
+skip_dma:
 	/* set the length as message for rx txn */
 	peripheral->rx_len = msgs[msg_idx].len;
 	peripheral->op = op;
@@ -740,9 +746,11 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[],
 	return 0;
 
 err_config:
-	dma_unmap_single(gi2c->se.dev->parent, addr,
-			 msgs[msg_idx].len, map_dirn);
-	i2c_put_dma_safe_msg_buf(dma_buf, &msgs[msg_idx], false);
+	if (op == I2C_WRITE && (msgs[msg_idx].flags & I2C_M_RD)) {
+		dma_unmap_single(gi2c->se.dev->parent, addr,
+				 msgs[msg_idx].len, map_dirn);
+		i2c_put_dma_safe_msg_buf(dma_buf, &msgs[msg_idx], false);
+	}
 
 out:
 	gi2c->err = ret;
-- 
2.34.1