LX2162A Clearfog has four LEDs attached physically to the 4-port SFP
connector. They are intended to show information relating to network
interface status.

Select "netdev" as default trigger for each LED, and link each one to
the respective dpmac instance as trigger-source.

Signed-off-by: Josua Mayer <josua@solid-run.com>
---
 arch/arm64/boot/dts/freescale/fsl-lx2162a-clearfog.dts | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/fsl-lx2162a-clearfog.dts b/arch/arm64/boot/dts/freescale/fsl-lx2162a-clearfog.dts
index 8920326a06735..9d50d3e2761da 100644
--- a/arch/arm64/boot/dts/freescale/fsl-lx2162a-clearfog.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-lx2162a-clearfog.dts
@@ -41,21 +41,29 @@ leds {
 		led_sfp_at: led-sfp-at {
 			gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; /* PROC_IRQ5 */
 			default-state = "off";
+			linux,default-trigger = "netdev";
+			trigger-sources = <&dpmac3>;
 		};
 
 		led_sfp_ab: led-sfp-ab {
 			gpios = <&gpio2 11 GPIO_ACTIVE_HIGH>; /* PROC_IRQ11 */
 			default-state = "off";
+			linux,default-trigger = "netdev";
+			trigger-sources = <&dpmac4>;
 		};
 
 		led_sfp_bt: led-sfp-bt {
 			gpios = <&gpio2 13 GPIO_ACTIVE_HIGH>; /* EVT1_B */
 			default-state = "off";
+			linux,default-trigger = "netdev";
+			trigger-sources = <&dpmac5>;
 		};
 
 		led_sfp_bb: led-sfp-bb {
 			gpios = <&gpio2 14 GPIO_ACTIVE_HIGH>; /* EVT2_B */
 			default-state = "off";
+			linux,default-trigger = "netdev";
+			trigger-sources = <&dpmac6>;
 		};
 	};
 

-- 
2.51.0