From: David Heidelberg <david@ixit.cz>

Inherit C-PHY information from CSIPHY, so we can configure CSID
properly.

CSI2_RX_CFG0_PHY_TYPE_SEL must be set to 1, when C-PHY mode is used.

Signed-off-by: David Heidelberg <david@ixit.cz>
---
 drivers/media/platform/qcom/camss/camss-csid-gen2.c | 1 +
 drivers/media/platform/qcom/camss/camss-csid.c      | 1 +
 drivers/media/platform/qcom/camss/camss-csid.h      | 1 +
 3 files changed, 3 insertions(+)

diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
index 2a1746dcc1c5b..033036ae28a4f 100644
--- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c
+++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
@@ -183,6 +183,7 @@ static void __csid_configure_rx(struct csid_device *csid,
 	val = (lane_cnt - 1) << CSI2_RX_CFG0_NUM_ACTIVE_LANES;
 	val |= phy->lane_assign << CSI2_RX_CFG0_DL0_INPUT_SEL;
 	val |= phy->csiphy_id << CSI2_RX_CFG0_PHY_NUM_SEL;
+	val |= csid->phy.cphy << CSI2_RX_CFG0_PHY_TYPE_SEL;
 	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0);
 
 	val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
diff --git a/drivers/media/platform/qcom/camss/camss-csid.c b/drivers/media/platform/qcom/camss/camss-csid.c
index ed1820488c987..b50b0cfe280c1 100644
--- a/drivers/media/platform/qcom/camss/camss-csid.c
+++ b/drivers/media/platform/qcom/camss/camss-csid.c
@@ -1275,6 +1275,7 @@ static int csid_link_setup(struct media_entity *entity,
 		csid->phy.csiphy_id = csiphy->id;
 
 		lane_cfg = &csiphy->cfg.csi2->lane_cfg;
+		csid->phy.cphy = (lane_cfg->phy_cfg == V4L2_MBUS_CSI2_CPHY);
 		csid->phy.lane_cnt = lane_cfg->num_data;
 		csid->phy.lane_assign = csid_get_lane_assign(lane_cfg);
 	}
diff --git a/drivers/media/platform/qcom/camss/camss-csid.h b/drivers/media/platform/qcom/camss/camss-csid.h
index aedc96ed84b2f..a82db31bd2335 100644
--- a/drivers/media/platform/qcom/camss/camss-csid.h
+++ b/drivers/media/platform/qcom/camss/camss-csid.h
@@ -70,6 +70,7 @@ struct csid_phy_config {
 	u32 lane_assign;
 	u32 en_vc;
 	u8 need_vc_update;
+	bool cphy;
 };
 
 struct csid_device;

-- 
2.51.0

On 01/03/2026 00:51, David Heidelberg via B4 Relay wrote:
> +	bool cphy;

Same comment as before, you should have an enum not a bool.

---
bod

On 03/03/2026 10:53, Bryan O'Donoghue wrote:
> On 01/03/2026 00:51, David Heidelberg via B4 Relay wrote:
>> +    bool cphy;
> 
> Same comment as before, you should have an enum not a bool.


While for general camss it makes sense to me, here it seems to be very simple 
switch with no other extra usefulness.

If u insist, I'll change it, but LGTM with cphy here.

David

> 
> ---
> bod

-- 
David Heidelberg