Rename node name uart8250 to serial to fix below CHECK_DTBS warnings:
arch/arm/boot/dts/nxp/imx/imx27-eukrea-mbimxsd27-baseboard.dtb: uart8250@3,200000 (ns8250): $nodename:0: 'uart8250@3,200000' does not match '^serial(@.*)?$'
Signed-off-by: Frank Li <Frank.Li@nxp.com>
---
arch/arm/boot/dts/nxp/imx/imx27-eukrea-cpuimx27.dtsi | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm/boot/dts/nxp/imx/imx27-eukrea-cpuimx27.dtsi b/arch/arm/boot/dts/nxp/imx/imx27-eukrea-cpuimx27.dtsi
index 87dd80fc7061eeef88eeb353edb042b9a631a356..b56652664b5e7fa8e9818020f48ff0c7a7658c03 100644
--- a/arch/arm/boot/dts/nxp/imx/imx27-eukrea-cpuimx27.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx27-eukrea-cpuimx27.dtsi
@@ -104,7 +104,7 @@ nor: flash@0,0 {
fsl,weim-cs-timing = <0x00008f03 0xa0330d01 0x002208c0>;
};
- uart8250@3,200000 {
+ serial@3,200000 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart8250_1>;
compatible = "ns8250";
@@ -117,7 +117,7 @@ uart8250@3,200000 {
no-loopback-test;
};
- uart8250@3,400000 {
+ serial@3,400000 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart8250_2>;
compatible = "ns8250";
@@ -130,7 +130,7 @@ uart8250@3,400000 {
no-loopback-test;
};
- uart8250@3,800000 {
+ serial@3,800000 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart8250_3>;
compatible = "ns8250";
@@ -143,7 +143,7 @@ uart8250@3,800000 {
no-loopback-test;
};
- uart8250@3,1000000 {
+ serial@3,1000000 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart8250_4>;
compatible = "ns8250";
--
2.43.0