This patch set adds usdhc1 support to enable M.2 SDIO WiFi on the
i.MX8MP EVK. The M.2 connector on this board can operate in both PCIe
and SDIO modes, and SDIO-based WLAN modules require proper power control
through the same M.2 WLAN enable line (W_DISABLE1 on pin 56).

The first two patches are preparation changes:
  - Patch 1 corrects the IOMUX configuration by enabling the pull-select
    bit for the M.2 regulator GPIO, ensuring that the weak pull-up is
    actually applied.
  - Patch 2 renames the regulator node from reg_pcie0 to reg_m2_wlan
    so that the same GPIO-controlled power rail can be cleanly reused by
    both PCIe- and SDIO-based WLAN modules.

The final patch enables usdhc1 and associated pinctrl settings needed
for SDIO WiFi operation on the M.2 connector.


Sherry Sun (3):
  arm64: dts: imx8mp-evk: Enable pull select bit for PCIe regulator GPIO
    (M.2 W_DISABLE1)
  arm64: dts: imx8mp-evk: Rename PCIe regulator to M.2 WLAN regulator
  arm64: dts: imx8mp-evk: Add usdhc1 for SDIO WiFi support

 arch/arm64/boot/dts/freescale/imx8mp-evk.dts | 81 +++++++++++++++++---
 1 file changed, 70 insertions(+), 11 deletions(-)

-- 
2.37.1