[PATCH v1 4/4] usb: phy: tegra: parametrize PORTSC1 register offset

Svyatoslav Ryhel posted 4 patches 6 days, 12 hours ago
[PATCH v1 4/4] usb: phy: tegra: parametrize PORTSC1 register offset
Posted by Svyatoslav Ryhel 6 days, 12 hours ago
The PORTSC1 register has a different offset in Tegra20 compared to
Tegra30+, yet they share a crucial set of registers required for HSIC
functionality. Reflect this register offset change in the SoC config.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>
---
 drivers/usb/phy/phy-tegra-usb.c   | 17 ++++++-----------
 include/linux/usb/tegra_usb_phy.h |  2 ++
 2 files changed, 8 insertions(+), 11 deletions(-)

diff --git a/drivers/usb/phy/phy-tegra-usb.c b/drivers/usb/phy/phy-tegra-usb.c
index 812d99443180..00443a7beaeb 100644
--- a/drivers/usb/phy/phy-tegra-usb.c
+++ b/drivers/usb/phy/phy-tegra-usb.c
@@ -965,17 +965,10 @@ static int uhsic_phy_power_on(struct tegra_usb_phy *phy)
 		writel_relaxed(val, base + USB_TXFILLTUNING);
 	}
 
-	if (phy->soc_config->has_hostpc) {
-		val = readl_relaxed(base + TEGRA30_USB_PORTSC1);
-		val &= ~(TEGRA_USB_PORTSC1_WKOC | TEGRA_USB_PORTSC1_WKDS |
-			 TEGRA_USB_PORTSC1_WKCN);
-		writel_relaxed(val, base + TEGRA30_USB_PORTSC1);
-	} else {
-		val = readl_relaxed(base + TEGRA_USB_PORTSC1);
-		val &= ~(TEGRA_USB_PORTSC1_WKOC | TEGRA_USB_PORTSC1_WKDS |
-			 TEGRA_USB_PORTSC1_WKCN);
-		writel_relaxed(val, base + TEGRA_USB_PORTSC1);
-	}
+	val = readl_relaxed(base + phy->soc_config->portsc1_offset);
+	val &= ~(TEGRA_USB_PORTSC1_WKOC | TEGRA_USB_PORTSC1_WKDS |
+		 TEGRA_USB_PORTSC1_WKCN);
+	writel_relaxed(val, base + phy->soc_config->portsc1_offset);
 
 	val = tegra_hsic_readl(phy, UHSIC_PADS_CFG0);
 	val &= ~UHSIC_TX_RTUNEN;
@@ -1472,6 +1465,7 @@ static const struct tegra_phy_soc_config tegra20_soc_config = {
 	.uhsic_registers_offset = 0,
 	.uhsic_tx_rtune = 0, /* 40 ohm */
 	.uhsic_pts_value = 0, /* UTMI */
+	.portsc1_offset = TEGRA_USB_PORTSC1,
 };
 
 static const struct tegra_phy_soc_config tegra30_soc_config = {
@@ -1483,6 +1477,7 @@ static const struct tegra_phy_soc_config tegra30_soc_config = {
 	.uhsic_registers_offset = 0x400,
 	.uhsic_tx_rtune = 8,  /* 50 ohm */
 	.uhsic_pts_value = TEGRA_USB_HOSTPC1_DEVLC_PTS_HSIC,
+	.portsc1_offset = TEGRA30_USB_PORTSC1,
 };
 
 static const struct of_device_id tegra_usb_phy_id_table[] = {
diff --git a/include/linux/usb/tegra_usb_phy.h b/include/linux/usb/tegra_usb_phy.h
index 81d9f22e58b5..57e22aae6247 100644
--- a/include/linux/usb/tegra_usb_phy.h
+++ b/include/linux/usb/tegra_usb_phy.h
@@ -28,6 +28,7 @@ struct gpio_desc;
  *      comparing to Tegra20 by 0x400, since Tegra20 has no UTMIP on PHY2
  * uhsic_tx_rtune: fine tuned 50 Ohm termination resistor for NMOS/PMOS driver
  * uhsic_pts_value: parallel transceiver select enumeration value
+ * portsc1_offset: register offset of PORTSC1
  */
 
 struct tegra_phy_soc_config {
@@ -39,6 +40,7 @@ struct tegra_phy_soc_config {
 	u32 uhsic_registers_offset;
 	u32 uhsic_tx_rtune;
 	u32 uhsic_pts_value;
+	u32 portsc1_offset;
 };
 
 struct tegra_utmip_config {
-- 
2.51.0