The parallel transceiver select used in HSIC mode differs on Tegra20,
where it uses the UTMI value (0), whereas Tegra30+ uses a dedicated HSIC
value. Reflect this in the SoC config.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>
---
 drivers/usb/phy/phy-tegra-usb.c   | 7 +++----
 include/linux/usb/tegra_usb_phy.h | 2 ++
 2 files changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/usb/phy/phy-tegra-usb.c b/drivers/usb/phy/phy-tegra-usb.c
index 6173b240c3ea..812d99443180 100644
--- a/drivers/usb/phy/phy-tegra-usb.c
+++ b/drivers/usb/phy/phy-tegra-usb.c
@@ -957,10 +957,7 @@ static int uhsic_phy_power_on(struct tegra_usb_phy *phy)
 		writel_relaxed(val, base + USB_USBMODE);
 	}
 
-	if (phy->soc_config->has_hostpc)
-		set_pts(phy, TEGRA_USB_HOSTPC1_DEVLC_PTS_HSIC);
-	else
-		set_pts(phy, 0);
+	set_pts(phy, phy->soc_config->uhsic_pts_value);
 
 	val = readl_relaxed(base + USB_TXFILLTUNING);
 	if ((val & USB_FIFO_TXFILL_MASK) != USB_FIFO_TXFILL_THRES(0x10)) {
@@ -1474,6 +1471,7 @@ static const struct tegra_phy_soc_config tegra20_soc_config = {
 	.requires_pmc_ao_power_up = false,
 	.uhsic_registers_offset = 0,
 	.uhsic_tx_rtune = 0, /* 40 ohm */
+	.uhsic_pts_value = 0, /* UTMI */
 };
 
 static const struct tegra_phy_soc_config tegra30_soc_config = {
@@ -1484,6 +1482,7 @@ static const struct tegra_phy_soc_config tegra30_soc_config = {
 	.requires_pmc_ao_power_up = true,
 	.uhsic_registers_offset = 0x400,
 	.uhsic_tx_rtune = 8,  /* 50 ohm */
+	.uhsic_pts_value = TEGRA_USB_HOSTPC1_DEVLC_PTS_HSIC,
 };
 
 static const struct of_device_id tegra_usb_phy_id_table[] = {
diff --git a/include/linux/usb/tegra_usb_phy.h b/include/linux/usb/tegra_usb_phy.h
index fbdd2dcb3a2b..81d9f22e58b5 100644
--- a/include/linux/usb/tegra_usb_phy.h
+++ b/include/linux/usb/tegra_usb_phy.h
@@ -27,6 +27,7 @@ struct gpio_desc;
  * uhsic_registers_offset: for Tegra30+ where HSIC registers were offset
  *      comparing to Tegra20 by 0x400, since Tegra20 has no UTMIP on PHY2
  * uhsic_tx_rtune: fine tuned 50 Ohm termination resistor for NMOS/PMOS driver
+ * uhsic_pts_value: parallel transceiver select enumeration value
  */
 
 struct tegra_phy_soc_config {
@@ -37,6 +38,7 @@ struct tegra_phy_soc_config {
 	bool requires_pmc_ao_power_up;
 	u32 uhsic_registers_offset;
 	u32 uhsic_tx_rtune;
+	u32 uhsic_pts_value;
 };
 
 struct tegra_utmip_config {
-- 
2.51.0