The "multiq3" driver uses an admin-supplied configuration option
(`it->options[0]`) to configure the I/O port base address of a Multiq-3
board.  It currently allows any base address to be configured but the
hardware only supports base addresses (configured by on-board jumpers)
in the range 0 to 0x3F0 on 16-byte boundaries.

Add a sanity check to ensure the device is not configured at an
unsupported base address.

Signed-off-by: Ian Abbott <abbotti@mev.co.uk>
---
 drivers/comedi/drivers/multiq3.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/comedi/drivers/multiq3.c b/drivers/comedi/drivers/multiq3.c
index ac369e9a262d..3dde3a1876d7 100644
--- a/drivers/comedi/drivers/multiq3.c
+++ b/drivers/comedi/drivers/multiq3.c
@@ -259,7 +259,8 @@ static int multiq3_attach(struct comedi_device *dev,
 	int ret;
 	int i;
 
-	ret = comedi_request_region(dev, it->options[0], 0x10);
+	ret = comedi_check_request_region(dev, it->options[0], 0x10,
+					  0, 0x3ff, 16);
 	if (ret)
 		return ret;
 
-- 
2.51.0