The LT9611 HDMI bridge has two DSI input ports (Port A and Port B).
The current driver only supports Port A or dual-port (A+B) mode, but
some boards like RubikPi3 connect DSI to Port B only.
This series adds support for using DSI Port B as the input source by
utilizing the existing ports mechanism in devicetree:
- port@0 corresponds to LT9611 DSI Port A input
- port@1 corresponds to LT9611 DSI Port B input
The driver detects which ports are populated and configures the hardware
accordingly. When only port@1 is present, it configures port swap
(register 0x8303 bit 6) and byte_clk source (register 0x8250 bit 3:2)
for Port B operation.
Signed-off-by: Hongyang Zhao <hongyang.zhao@thundersoft.com>
---
Changes in v2:
- Use ports mechanism instead of boolean property
- port@0 corresponds to LT9611 Port A, port@1 to Port B
- Driver detects which port is populated and configures accordingly
- Link to v1: https://lore.kernel.org/r/20260127-rubikpi-next-20260116-v1-0-0286c75150c5@thundersoft.com
---
Hongyang Zhao (3):
dt-bindings: display: lt9611: Support single Port B input
drm/bridge: lt9611: Add support for single Port B input
arm64: dts: qcom: qcs6490-rubikpi3: Use lt9611 DSI Port B
.../bindings/display/bridge/lontium,lt9611.yaml | 15 +++++--
.../boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts | 8 ++--
drivers/gpu/drm/bridge/lontium-lt9611.c | 46 +++++++++++++++-------
3 files changed, 47 insertions(+), 22 deletions(-)
---
base-commit: 46fe65a2c28ecf5df1a7475aba1f08ccf4c0ac1b
change-id: 20260127-rubikpi-next-20260116-99c1dbea50e4
Best regards,
--
Hongyang Zhao <hongyang.zhao@thundersoft.com>