From: Andrea Scian <andrea.scian@dave.eu>

This just add some information on kernel log about the selected ECC

Signed-off-by: Andrea Scian <andrea.scian@dave.eu>
---
 drivers/mtd/nand/raw/pl35x-nand-controller.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/mtd/nand/raw/pl35x-nand-controller.c b/drivers/mtd/nand/raw/pl35x-nand-controller.c
index fcb62b9ec947b..cbef4f0084844 100644
--- a/drivers/mtd/nand/raw/pl35x-nand-controller.c
+++ b/drivers/mtd/nand/raw/pl35x-nand-controller.c
@@ -970,16 +970,19 @@ static int pl35x_nand_attach_chip(struct nand_chip *chip)
 
 	switch (chip->ecc.engine_type) {
 	case NAND_ECC_ENGINE_TYPE_ON_DIE:
+		dev_dbg(nfc->dev, "Using on-die ECC\n");
 		/* Keep these legacy BBT descriptors for ON_DIE situations */
 		chip->bbt_td = &bbt_main_descr;
 		chip->bbt_md = &bbt_mirror_descr;
 		fallthrough;
 	case NAND_ECC_ENGINE_TYPE_NONE:
 	case NAND_ECC_ENGINE_TYPE_SOFT:
+		dev_dbg(nfc->dev, "Using software ECC (Hamming 1-bit/512B)\n");
 		chip->ecc.algo = NAND_ECC_ALGO_HAMMING;
 		chip->ecc.write_page_raw = nand_monolithic_write_page_raw;
 		break;
 	case NAND_ECC_ENGINE_TYPE_ON_HOST:
+		dev_dbg(nfc->dev, "Using hardware ECC\n");
 		ret = pl35x_nand_init_hw_ecc_controller(nfc, chip);
 		if (ret)
 			return ret;

-- 
2.43.0