RDP433 can have NAND or eMMC based on a board level rework. Since the
same GPIOS are used for both the interfaces, only one of them can be
used. Add a new DTS file to disable NAND and enable eMMC.

v2: Create two separate DTS files for the NAND and eMMC variants as
    suggested in the review.

v1: https://lore.kernel.org/linux-arm-msm/20260102104638.3802715-1-varadarajan.narayanan@oss.qualcomm.com/

Varadarajan Narayanan (4):
  arm64: dts: qcom: ipq9574: Add gpio details for eMMC
  arm64: dts: qcom: ipq9574-rdp433: Reorganize DTS to introduce eMMC
    support
  dt-bindings: arm: qcom: Add IPQ9574 AL02-c7 eMMC variant
  arm64: dts: qcom: ipq9574: Enable eMMC variant

 .../devicetree/bindings/arm/qcom.yaml         |   1 +
 arch/arm64/boot/dts/qcom/Makefile             |   2 +-
 .../boot/dts/qcom/ipq9574-rdp-common.dtsi     |  32 +++++
 .../boot/dts/qcom/ipq9574-rdp433-common.dtsi  | 121 ++++++++++++++++++
 .../boot/dts/qcom/ipq9574-rdp433-emmc.dts     |  32 +++++
 arch/arm64/boot/dts/qcom/ipq9574-rdp433.dts   | 116 +----------------
 6 files changed, 188 insertions(+), 116 deletions(-)
 create mode 100644 arch/arm64/boot/dts/qcom/ipq9574-rdp433-common.dtsi
 create mode 100644 arch/arm64/boot/dts/qcom/ipq9574-rdp433-emmc.dts


base-commit: c072629f05d7bca1148ab17690d7922a31423984
-- 
2.34.1