This series of patches mainly addresses two issues:
1. Fix potential timing issues that may occur during the first and second power on.
If the reset GPIO happens to default to the deasserted state at the very
first power-up, the previous sequence could let the sensor run before
supplies/clock are fully stable, while subsequent power cycles would
differ because the driver explicitly toggles reset. This results in
inconsistent power on sequences between the first and later power on.

2. The Arducam IMX577 sensor requires a longer reset time.

Changes in v7:
- Add vendor details to the comments. -- Sakari
- Link to v6: https://lore.kernel.org/r/20260122-imx412-v6-0-2c0b54594c2a@oss.qualcomm.com

Changes in v6:
- Added comments for the modifications. -- Sakari
- Link to v5: https://lore.kernel.org/r/20260121-imx412-v5-0-be67654a4afe@oss.qualcomm.com

Changes in v5:
- Assert reset GPIO in imx412_parse_hw_config. -- Tarang
- Link to v4: https://lore.kernel.org/r/20260121-imx412-v4-0-f6bdf83f116b@oss.qualcomm.com

Changes in v4:
- Add assert reset in probe. -- Sakari
- Link to v3: https://lore.kernel.org/r/20260119-imx412-v3-0-8b46929af773@oss.qualcomm.com

Changes in v3:
- Fix power on timing. -- Bryan.
- Add reset delay time for Arducam Imx577.
- Link to v2: https://lore.kernel.org/all/20260109044913.3310-1-wenmeng.liu@oss.qualcomm.com/

Changes in v2:
- Move the 7.4–8 ms delay before mode-register programming to satisfy T7 (NVM read).
- Link to v1: https://lore.kernel.org/all/20251222-imx412-v1-1-51c7e724b376@oss.qualcomm.com/

---
Wenmeng Liu (2):
      media: i2c: imx412: Assert reset GPIO during probe
      media: i2c: imx412: Extend the power-on waiting time

 drivers/media/i2c/imx412.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)
---
base-commit: e3b32dcb9f23e3c3927ef3eec6a5842a988fb574
change-id: 20260119-imx412-d6710b9fd3c6

Best regards,
-- 
Wenmeng Liu <wenmeng.liu@oss.qualcomm.com>