This series introduces two changes:

1. Extend the MCP251XFD binding to allow GPIO hog child nodes. The
   MCP251XFD family can expose two pins as GPIOs. The binding already
   declares 'gpio-controller' and '#gpio-cells'. Adding a
   'patternProperties' entry permits boards to define hog nodes for default
   GPIO states at boot, which aligns with other GPIO controller bindings
   (e.g., microchip,mpfs-gpio).

2. Enable the MCP2518FD CAN controller on the QCS6490 RB3 Gen2 platform.
   The controller is connected via SPI3 and uses a 40 MHz oscillator.
   A GPIO hog for GPIO0 is included to configure the CAN transceiver in
   Normal mode during boot.
 
Viken Dadhaniya (2):
  dt-bindings: can: microchip,mcp251xfd: allow gpio-hog child nodes
  arm64: dts: qcom: qcs6490-rb3gen2: Enable CAN bus controller

 .../bindings/net/can/microchip,mcp251xfd.yaml |  6 ++++
 arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts  | 30 +++++++++++++++++++
 2 files changed, 36 insertions(+)

-- 
2.34.1