Check return value of mt7925_mcu_add_bss_info() in mt7925_mac_link_sta_add()
and propagate errors to the caller.

BSS info must be set up before adding a station record. If this MCU
command fails, continuing with station add would leave the firmware in
an inconsistent state with a station but no BSS configuration.

This can cause undefined behavior in the firmware, particularly during
MLO link setup where multiple BSS configurations are being programmed.

Reported-by: Zac Bowling <zac@zacbowling.com>
Fixes: c948b5da6bbe ("wifi: mt76: mt7925: add Mediatek Wi-Fi7 driver for mt7925 chips")
Signed-off-by: Zac Bowling <zac@zacbowling.com>
---
 drivers/net/wireless/mediatek/mt76/mt7925/main.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/net/wireless/mediatek/mt76/mt7925/main.c b/drivers/net/wireless/mediatek/mt76/mt7925/main.c
index d966e5ab50ff..a7e1e673c4bc 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7925/main.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7925/main.c
@@ -899,11 +899,14 @@ static int mt7925_mac_link_sta_add(struct mt76_dev *mdev,
 	/* should update bss info before STA add */
 	if (vif->type == NL80211_IFTYPE_STATION && !link_sta->sta->tdls) {
 		if (ieee80211_vif_is_mld(vif))
-			mt7925_mcu_add_bss_info(&dev->phy, mconf->mt76.ctx,
-						link_conf, link_sta, link_sta != mlink->pri_link);
+			ret = mt7925_mcu_add_bss_info(&dev->phy, mconf->mt76.ctx,
+						      link_conf, link_sta,
+						      link_sta != mlink->pri_link);
 		else
-			mt7925_mcu_add_bss_info(&dev->phy, mconf->mt76.ctx,
-						link_conf, link_sta, false);
+			ret = mt7925_mcu_add_bss_info(&dev->phy, mconf->mt76.ctx,
+						      link_conf, link_sta, false);
+		if (ret)
+			return ret;
 	}
 
 	if (ieee80211_vif_is_mld(vif) &&
-- 
2.51.0