If the driver does not clear the status when disabling the trace buffer
unit, stale state will carry over to the next enable, though the driver
clears it again on enable.

Explicitly clear status after the trace is disabled in the interrupt
handling and when a perf session ends.  Keep the status for spurious
interrupts for continuous tracing.

Signed-off-by: Leo Yan <leo.yan@arm.com>
---
 drivers/hwtracing/coresight/coresight-trbe.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/hwtracing/coresight/coresight-trbe.c b/drivers/hwtracing/coresight/coresight-trbe.c
index e426991e2c2c398a9d3982e9d0f7f542e404cbab..9e565122816949b37b8ff5e4ba04cfbc317c6f25 100644
--- a/drivers/hwtracing/coresight/coresight-trbe.c
+++ b/drivers/hwtracing/coresight/coresight-trbe.c
@@ -629,7 +629,6 @@ static void trbe_enable_hw(struct trbe_buf *buf)
 	WARN_ON(buf->trbe_hw_base < buf->trbe_base);
 	WARN_ON(buf->trbe_write < buf->trbe_hw_base);
 	WARN_ON(buf->trbe_write >= buf->trbe_limit);
-	clr_trbe_status();
 	set_trbe_base_pointer(buf->trbe_hw_base);
 	set_trbe_write_pointer(buf->trbe_write);
 
@@ -1036,6 +1035,8 @@ static int arm_trbe_disable(struct coresight_device *csdev)
 		return -EINVAL;
 
 	trbe_drain_and_disable_local(cpudata);
+	clr_trbe_status();
+
 	buf->cpudata = NULL;
 	cpudata->buf = NULL;
 	cpudata->mode = CS_MODE_DISABLED;
@@ -1151,6 +1152,10 @@ static irqreturn_t arm_trbe_irq_handler(int irq, void *dev)
 		return IRQ_NONE;
 
 	act = trbe_get_fault_act(handle, status);
+
+	if (act != TRBE_FAULT_ACT_SPURIOUS)
+		clr_trbe_status();
+
 	switch (act) {
 	case TRBE_FAULT_ACT_WRAP:
 		truncated = !!trbe_handle_overflow(handle);

-- 
2.34.1