This patch series adds support for the CMN PLL block on the IPQ5332 SoC.
The CMN PLL implementation in IPQ5332 is largely similar to that of
IPQ9574, which is already supported by the driver. The primary difference
is that the fixed output clocks to PPE from the CMN PLL operate at 200 MHz.

Additionally, IPQ5332 provides a single 50 MHz clock to both UNIPHY (PCS)
instances, which in turn supply either 25 MHz or 50 MHz to the connected
Ethernet PHY or switch.

This series also introduces a SoC-specific header file to export the CMN
PLL output clock specifiers for IPQ5332. A new table of output clocks for
the CMN PLL is added, and the appropriate clocks are acquired from the
device based on the compatible string.

Account for the CMN PLL reference divider when calculating CMN PLL output
rate. This fixes the doubled rate observed on IPQ5332 and is a no-op on
earlier platforms where ref_div = 1.

Signed-off-by: Luo Jie <jie.luo@oss.qualcomm.com>
---
Luo Jie (5):
      clk: qcom: cmnpll: Account for reference clock divider
      dt-bindings: clock: qcom: Add CMN PLL support for IPQ5332 SoC
      clk: qcom: cmnpll: Add IPQ5332 SoC support
      arm64: dts: ipq5332: Add CMN PLL node for networking hardware
      arm64: dts: qcom: Represent xo_board as fixed-factor clock on IPQ5332

 .../bindings/clock/qcom,ipq9574-cmn-pll.yaml       |  1 +
 arch/arm64/boot/dts/qcom/ipq5332-rdp-common.dtsi   | 24 +++++++++++++++--
 arch/arm64/boot/dts/qcom/ipq5332.dtsi              | 27 ++++++++++++++++++-
 drivers/clk/qcom/ipq-cmn-pll.c                     | 30 +++++++++++++++++++---
 include/dt-bindings/clock/qcom,ipq5332-cmn-pll.h   | 19 ++++++++++++++
 5 files changed, 95 insertions(+), 6 deletions(-)
---
base-commit: 7d31f578f3230f3b7b33b0930b08f9afd8429817
change-id: 20251127-qcom_ipq5332_cmnpll-bc27e042d08d

Best regards,
--  
Luo Jie <jie.luo@oss.qualcomm.com>