Explains the GPIO controller support with emphasis on the mask
depending on which GPs are exposed.
Signed-off-by: Jorge Marques <jorge.marques@analog.com>
---
Documentation/iio/ad4062.rst | 13 ++++++++++++-
1 file changed, 12 insertions(+), 1 deletion(-)
diff --git a/Documentation/iio/ad4062.rst b/Documentation/iio/ad4062.rst
index 5afec4d8c2ddb..78665755ebebc 100644
--- a/Documentation/iio/ad4062.rst
+++ b/Documentation/iio/ad4062.rst
@@ -29,6 +29,9 @@ the devicetree ``interrupt-names`` property:
- GP0: Is assigned the role of Threshold Either signal.
- GP1: Is assigned the role of Data Ready signal.
+If the property ``gpio-controller`` is present in the devicetree, then the GPO
+not present in the ``interrupt-names`` is exposed as a GPO.
+
Device attributes
=================
@@ -135,9 +138,17 @@ The following event attributes are available:
* - ``thresh_rising_value``
- Set the maximum threshold value.
+GPO controller support
+======================
+
+The device supports using GP0 and GP1 as GPOs. If the devicetree contains the
+node ``gpio-controller```, the device is marked as a GPIO controller and the
+GPs not listed in ``interrupt-names`` are exposed as a GPO. The GPIO index
+matches the pin name, so if GP0 is not exposed but GP1 is, index 0 is masked
+out and only index 1 can be set.
+
Unimplemented features
======================
- Trigger mode
- Averaging mode
-- General purpose output
--
2.51.1