From: Rudraksha Gupta <guptarud@gmail.com>

Add pn544 NFC chip

Signed-off-by: Rudraksha Gupta <guptarud@gmail.com>
---
 .../dts/qcom/qcom-msm8960-samsung-expressatt.dts   | 45 ++++++++++++++++++++++
 1 file changed, 45 insertions(+)

diff --git a/arch/arm/boot/dts/qcom/qcom-msm8960-samsung-expressatt.dts b/arch/arm/boot/dts/qcom/qcom-msm8960-samsung-expressatt.dts
index 8d75ebd7976c..4f9b59db7bc3 100644
--- a/arch/arm/boot/dts/qcom/qcom-msm8960-samsung-expressatt.dts
+++ b/arch/arm/boot/dts/qcom/qcom-msm8960-samsung-expressatt.dts
@@ -182,6 +182,22 @@ touchscreen: touchscreen-int-state {
 		bias-disable;
 		drive-strength = <2>;
 	};
+
+	nfc_default: nfc-default-state {
+		irq-pins {
+			pins = "gpio106";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-down;
+		};
+
+		firmware-pins {
+			pins = "gpio92";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-disable;
+		};
+	};
 };
 
 &pm8921 {
@@ -195,6 +211,14 @@ prox_sensor_int: prox-sensor-int-state {
 		input-enable;
 		bias-disable;
 	};
+
+	nfc_enable: nfc-enable-state {
+		pins = "gpio21";
+		function = "normal";
+		bias-disable;
+		qcom,drive-strength = <PMIC_GPIO_STRENGTH_LOW>;
+		power-source = <PM8921_GPIO_S4>;
+	};
 };
 
 &rpm {
@@ -442,3 +466,24 @@ &usb1 {
 	dr_mode = "otg";
 	status = "okay";
 };
+
+&gsbi7 {
+	qcom,mode = <GSBI_PROT_I2C>;
+
+	status = "okay";
+};
+
+&gsbi7_i2c {
+	status = "okay";
+
+	nfc@2b {
+		compatible = "nxp,pn544-i2c";
+		reg = <0x2b>;
+		interrupts-extended = <&tlmm 106 IRQ_TYPE_EDGE_RISING>;
+		enable-gpios = <&pm8921_gpio 21 GPIO_ACTIVE_HIGH>;
+		firmware-gpios = <&tlmm 92 GPIO_ACTIVE_HIGH>;
+
+		pinctrl-0 = <&nfc_default &nfc_enable>;
+		pinctrl-names = "default";
+	};
+};

-- 
2.52.0

On 11/23/25 7:44 AM, Rudraksha Gupta via B4 Relay wrote:
> From: Rudraksha Gupta <guptarud@gmail.com>
> 
> Add pn544 NFC chip
> 
> Signed-off-by: Rudraksha Gupta <guptarud@gmail.com>
> ---

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad