"Command Read/Write" section has two DataByte* subsections describing
command bytes format. Add markup to these subsection heading texts.

Signed-off-by: Bagas Sanjaya <bagasdotme@gmail.com>
---
 Documentation/hid/hid-alps.rst | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/hid/hid-alps.rst b/Documentation/hid/hid-alps.rst
index 3a22254e43464f..4a22a357f00c02 100644
--- a/Documentation/hid/hid-alps.rst
+++ b/Documentation/hid/hid-alps.rst
@@ -69,6 +69,7 @@ To read/write to RAM, need to send a command to the device.
 The command format is as below.
 
 DataByte(SET_REPORT)
+~~~~~~~~~~~~~~~~~~~~
 
 =====	======================
 Byte1	Command Byte
@@ -89,6 +90,7 @@ Value Byte is writing data when you send the write commands.
 When you read RAM, there is no meaning.
 
 DataByte(GET_REPORT)
+~~~~~~~~~~~~~~~~~~~~
 
 =====	======================
 Byte1	Response Byte
-- 
An old man doll... just what I always wanted! - Clara