On Wed Sep 17, 2025 at 3:36 PM CEST, Suraj Gupta wrote:
> Optimize AXI DMA control register programming by consolidating
> coalesce count and delay configuration into a single register write.
> Previously, the coalesce count was written separately from the delay
> configuration, resulting in two register writes. Combine these into
> one write operation to reduce bus overhead.
> Additionally, avoid redundant channel starts by only calling
> xilinx_dma_start() when the channel is actually idle.
>
> Signed-off-by: Suraj Gupta <suraj.gupta2@amd.com>
Tested-by: Folker Schwesinger <dev@folker-schwesinger.de>
> ---
> drivers/dma/xilinx/xilinx_dma.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/dma/xilinx/xilinx_dma.c b/drivers/dma/xilinx/xilinx_dma.c
> index 7211c394cdca..6e9bf4732ded 100644
> --- a/drivers/dma/xilinx/xilinx_dma.c
> +++ b/drivers/dma/xilinx/xilinx_dma.c
> @@ -1561,7 +1561,6 @@ static void xilinx_dma_start_transfer(struct xilinx_dma_chan *chan)
> reg &= ~XILINX_DMA_CR_COALESCE_MAX;
> reg |= chan->desc_pendingcount <<
> XILINX_DMA_CR_COALESCE_SHIFT;
> - dma_ctrl_write(chan, XILINX_DMA_REG_DMACR, reg);
> }
>
> if (chan->has_sg && list_empty(&chan->active_list))
> @@ -1571,7 +1570,8 @@ static void xilinx_dma_start_transfer(struct xilinx_dma_chan *chan)
> reg |= chan->irq_delay << XILINX_DMA_CR_DELAY_SHIFT;
> dma_ctrl_write(chan, XILINX_DMA_REG_DMACR, reg);
>
> - xilinx_dma_start(chan);
> + if (chan->idle)
> + xilinx_dma_start(chan);
>
> if (chan->err)
> return;