Drop post-power-on-delay-ms from mmc0 mmc1 interfaces. There is no
known reason for these properties to continue, testing appears to be fine
without them [1].

1: https://lore.kernel.org/lkml/NT0PR01MB1312E0D9EE9F158A57B77700E63D2@NT0PR01MB1312.CHNPR01.prod.partner.outlook.cn/

Signed-off-by: E Shattow <e@freeshell.de>
Tested-by: Hal Feng <hal.feng@starfivetech.com>
---
 arch/riscv/boot/dts/starfive/jh7110-common.dtsi | 2 --
 1 file changed, 2 deletions(-)

diff --git a/arch/riscv/boot/dts/starfive/jh7110-common.dtsi b/arch/riscv/boot/dts/starfive/jh7110-common.dtsi
index 4fa77ffd54e3..5dc15e48b74b 100644
--- a/arch/riscv/boot/dts/starfive/jh7110-common.dtsi
+++ b/arch/riscv/boot/dts/starfive/jh7110-common.dtsi
@@ -285,7 +285,6 @@ &mmc0 {
 	mmc-ddr-1_8v;
 	mmc-hs200-1_8v;
 	cap-mmc-hw-reset;
-	post-power-on-delay-ms = <200>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc0_pins>;
 	vmmc-supply = <&vcc_3v3>;
@@ -302,7 +301,6 @@ &mmc1 {
 	cd-gpios = <&sysgpio 41 GPIO_ACTIVE_LOW>;
 	disable-wp;
 	cap-sd-highspeed;
-	post-power-on-delay-ms = <200>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc1_pins>;
 	status = "okay";
-- 
2.50.0