The chip does not receive an interrupt if the monitor was connected
before powering up.
Therefore, you need to wake up the task if the necessary bits are set
when calling bridge_detect() after DRM is started.

Signed-off-by: Vladimir Yakovlev <vovchkir@gmail.com>
---
 drivers/gpu/drm/bridge/lontium-lt9611uxc.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/bridge/lontium-lt9611uxc.c b/drivers/gpu/drm/bridge/lontium-lt9611uxc.c
index 748bed8acd2d..5051cdfe2fee 100644
--- a/drivers/gpu/drm/bridge/lontium-lt9611uxc.c
+++ b/drivers/gpu/drm/bridge/lontium-lt9611uxc.c
@@ -358,17 +358,24 @@ static enum drm_connector_status lt9611uxc_bridge_detect(struct drm_bridge *brid
 	unsigned int reg_val = 0;
 	int ret;
 	bool connected = true;
+	bool edid_read = true;
 
 	lt9611uxc_lock(lt9611uxc);
 
 	if (lt9611uxc->hpd_supported) {
 		ret = regmap_read(lt9611uxc->regmap, 0xb023, &reg_val);
 
-		if (ret)
+		if (ret) {
 			dev_err(lt9611uxc->dev, "failed to read hpd status: %d\n", ret);
-		else
+		} else {
+			dev_dbg(lt9611uxc->dev, "detect() reg[0xb023]=0x%02X\n", reg_val);
 			connected  = reg_val & BIT(1);
+			edid_read = reg_val & BIT(0);
+			if (edid_read)
+				wake_up_all(&lt9611uxc->wq);
+		}
 	}
+	lt9611uxc->edid_read = edid_read;
 	lt9611uxc->hdmi_connected = connected;
 
 	lt9611uxc_unlock(lt9611uxc);
-- 
2.34.1