The TJA1051T/3 used on i.MX95-15x15-EVK is actually high-speed CAN
transceiver, not a regulator supply. So use phys to reflect the truth.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
---
 arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
index 46f6e0fbf2b09106e6e726ff8b61522d1359cfa4..f6197ba356d49b97bf7287c3f0f86ef84f89bac9 100644
--- a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
@@ -89,12 +89,11 @@ reg_audio_switch1: regulator-audio-switch1 {
 		gpio = <&pcal6524 0 GPIO_ACTIVE_LOW>;
 	};
 
-	reg_can2_stby: regulator-can2-stby {
-		compatible = "regulator-fixed";
-		regulator-max-microvolt = <3300000>;
-		regulator-min-microvolt = <3300000>;
-		regulator-name = "can2-stby";
-		gpio = <&pcal6524 14 GPIO_ACTIVE_LOW>;
+	flexcan2_phy: can-phy {
+		compatible = "nxp,tja1051", "ti,tcan1043";
+		#phy-cells = <0>;
+		max-bitrate = <1000000>;
+		standby-gpios = <&pcal6524 14 GPIO_ACTIVE_HIGH>;
 	};
 
 	reg_m2_pwr: regulator-m2-pwr {
@@ -300,7 +299,7 @@ &enetc_port1 {
 &flexcan2 {
 	pinctrl-0 = <&pinctrl_flexcan2>;
 	pinctrl-names = "default";
-	xceiver-supply = <&reg_can2_stby>;
+	phys = <&flexcan2_phy>;
 	status = "okay";
 };
 

-- 
2.37.1