From: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com>
When stress-testing the system by repeatedly unbinding and binding the ADC
device in a loop, and the ADC is a supplier for another device (e.g., a
thermal hardware block that reads temperature through the ADC), it may
happen that the ADC device is runtime-resumed immediately after runtime PM
is enabled, triggered by its consumer. At this point, since drvdata is not
yet set and the driver's runtime PM callbacks rely on it, a crash can
occur. To avoid this, set drvdata just after it was allocated.
Fixes: 89ee8174e8c8 ("iio: adc: rzg2l_adc: Simplify the runtime PM code")
Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com>
---
Changes in v5:
- none; this patch is new
drivers/iio/adc/rzg2l_adc.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/iio/adc/rzg2l_adc.c b/drivers/iio/adc/rzg2l_adc.c
index 0cb5a67fd497..cadb0446bc29 100644
--- a/drivers/iio/adc/rzg2l_adc.c
+++ b/drivers/iio/adc/rzg2l_adc.c
@@ -427,6 +427,8 @@ static int rzg2l_adc_probe(struct platform_device *pdev)
if (!indio_dev)
return -ENOMEM;
+ platform_set_drvdata(pdev, indio_dev);
+
adc = iio_priv(indio_dev);
adc->hw_params = device_get_match_data(dev);
@@ -459,8 +461,6 @@ static int rzg2l_adc_probe(struct platform_device *pdev)
if (ret)
return ret;
- platform_set_drvdata(pdev, indio_dev);
-
ret = rzg2l_adc_hw_init(dev, adc);
if (ret)
return dev_err_probe(&pdev->dev, ret,
--
2.43.0