This is needed for AP mode. Otherwise client sees the network, but
can't connect to it.

REG_FWHW_TXQ_CTRL+1 is set to WLAN_TXQ_RPT_EN (0x1F) in common mac
init function (__rtw8723x_mac_init), but the value was overwritten
from mac table later. mac_postinit is run after registers from mac
table are set, this allows to set correct values.

Tested on rtl8723cs, that reuses rtw8703b driver.

Changes in v2:
- introduce mac_postinit callback to avoid changing register tables

Andrey Skvortsov (2):
  wifi: rtw88: introduce callback to override phy parameters from tables
  wifi: rtw88: enable TX reports for the management queue

 drivers/net/wireless/realtek/rtw88/mac.c      | 11 +++++++++++
 drivers/net/wireless/realtek/rtw88/mac.h      |  1 +
 drivers/net/wireless/realtek/rtw88/main.c     |  6 ++++++
 drivers/net/wireless/realtek/rtw88/main.h     |  1 +
 drivers/net/wireless/realtek/rtw88/rtw8703b.c |  1 +
 drivers/net/wireless/realtek/rtw88/rtw8723d.c |  1 +
 drivers/net/wireless/realtek/rtw88/rtw8723x.c |  9 ++++++++-
 drivers/net/wireless/realtek/rtw88/rtw8723x.h |  6 ++++++
 8 files changed, 35 insertions(+), 1 deletion(-)

-- 
2.47.2