Add a dts for the PMIC used e.g. with SM7635 devices.
Signed-off-by: Luca Weiss <luca.weiss@fairphone.com>
---
arch/arm64/boot/dts/qcom/pmiv0104.dtsi | 63 ++++++++++++++++++++++++++++++++++
1 file changed, 63 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/pmiv0104.dtsi b/arch/arm64/boot/dts/qcom/pmiv0104.dtsi
new file mode 100644
index 0000000000000000000000000000000000000000..04d929db76f409c49c47ef0147a3de568006973a
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/pmiv0104.dtsi
@@ -0,0 +1,63 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2025, Luca Weiss <luca.weiss@fairphone.com>
+ */
+
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+/ {
+ thermal-zones {
+ pmiv0104-thermal {
+ polling-delay-passive = <100>;
+
+ thermal-sensors = <&pmiv0104_temp_alarm>;
+
+ trips {
+ trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
+
+ trip1 {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "hot";
+ };
+ };
+ };
+ };
+};
+
+&spmi_bus {
+ pmic@PMIV0104_SID {
+ compatible = "qcom,pmiv0104", "qcom,spmi-pmic";
+ reg = <PMIV0104_SID SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ pmiv0104_temp_alarm: temp-alarm@a00 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0xa00>;
+ interrupts = <PMIV0104_SID 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+ #thermal-sensor-cells = <0>;
+ };
+
+ pmiv0104_gpios: gpio@8800 {
+ compatible = "qcom,pmiv0104-gpio", "qcom,spmi-gpio";
+ reg = <0x8800>;
+ gpio-controller;
+ gpio-ranges = <&pmiv0104_gpios 0 0 10>;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ pmiv0104_eusb2_repeater: phy@fd00 {
+ compatible = "qcom,pmiv0104-eusb2-repeater";
+ reg = <0xfd00>;
+ #phy-cells = <0>;
+ };
+ };
+};
--
2.50.0