From: Dimitri Fedrau <dimitri.fedrau@liebherr.com>

Add property tx-amplitude-100base-tx-percent in the device tree bindings
for configuring the tx amplitude of 100BASE-TX PHYs. Modifying it can be
necessary to compensate losses on the PCB and connector, so the voltages
measured on the RJ45 pins are conforming.

Acked-by: Conor Dooley <conor.dooley@microchip.com>
Signed-off-by: Dimitri Fedrau <dimitri.fedrau@liebherr.com>
---
 Documentation/devicetree/bindings/net/ethernet-phy.yaml | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 2c71454ae8e362e7032e44712949e12da6826070..824bbe4333b7ed95cc39737d3c334a20aa890f01 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -232,6 +232,12 @@ properties:
       PHY's that have configurable TX internal delays. If this property is
       present then the PHY applies the TX delay.
 
+  tx-amplitude-100base-tx-percent:
+    description:
+      Transmit amplitude gain applied for 100BASE-TX. 100% matches 2V
+      peak-to-peak specified in ANSI X3.263. When omitted, the PHYs default
+      will be left as is.
+
   leds:
     type: object
 

-- 
2.39.5

On Fri, Feb 14, 2025 at 03:14:09PM +0100, Dimitri Fedrau via B4 Relay wrote:
> From: Dimitri Fedrau <dimitri.fedrau@liebherr.com>
> 
> Add property tx-amplitude-100base-tx-percent in the device tree bindings
> for configuring the tx amplitude of 100BASE-TX PHYs. Modifying it can be
> necessary to compensate losses on the PCB and connector, so the voltages
> measured on the RJ45 pins are conforming.
> 
> Acked-by: Conor Dooley <conor.dooley@microchip.com>
> Signed-off-by: Dimitri Fedrau <dimitri.fedrau@liebherr.com>

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew