Enable primary USB controller on QCS615 Ride platform. The primary USB
controller is made "peripheral", as this is intended to be connected to
a host for debugging use cases.

For using the controller in host mode, changing the dr_mode and adding
appropriate pinctrl nodes to provide vbus would be sufficient.

Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
---
 arch/arm64/boot/dts/qcom/qcs615-ride.dts | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
index ee6cab3924a6..a25928933e2b 100644
--- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
@@ -214,6 +214,29 @@ &uart0 {
 	status = "okay";
 };
 
+&usb_1_hsphy {
+	vdd-supply = <&vreg_l5a>;
+	vdda-pll-supply = <&vreg_l12a>;
+	vdda-phy-dpdm-supply = <&vreg_l13a>;
+
+	status = "okay";
+};
+
+&usb_qmpphy {
+	vdda-phy-supply = <&vreg_l5a>;
+	vdda-pll-supply = <&vreg_l12a>;
+
+	status = "okay";
+};
+
+&usb_1 {
+	status = "okay";
+};
+
+&usb_1_dwc3 {
+	dr_mode = "peripheral";
+};
+
 &watchdog {
 	clocks = <&sleep_clk>;
 };
-- 
2.34.1

On Thu, Nov 21, 2024 at 12:00:07PM +0530, Krishna Kurapati wrote:
> Enable primary USB controller on QCS615 Ride platform. The primary USB
> controller is made "peripheral", as this is intended to be connected to
> a host for debugging use cases.
> 
> For using the controller in host mode, changing the dr_mode and adding
> appropriate pinctrl nodes to provide vbus would be sufficient.
> 
> Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
> ---
>  arch/arm64/boot/dts/qcom/qcs615-ride.dts | 23 +++++++++++++++++++++++
>  1 file changed, 23 insertions(+)
> 

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> 

-- 
With best wishes
Dmitry