Since both the 'alpha' and 'alpha_hi' members of the configuration is
initialized (the latter is implicitly) with zero values, the output
rate of the PLL will be the same whether alpha mode is enabled or not.
Remove the initialization of the alpha* members to make it clear that
the alpha mode is not required to get the desired output rate.
Despite that enabling alpha mode is not needed for the initial
configuration, the set_rate() op might require that it is enabled
already. In this particular case however, the clk_alpha_pll_set_rate()
function will get reset the ALPHA_EN bit when the PLL's rate changes,
so dropping 'alpha_en_mask' is safe.
No functional changes intended, compile tested only.
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Gabor Juhos <j4g8y7@gmail.com>
---
Changes in v2:
- extend the commit message to indicate that dropping 'alpha_en_mask' is safe
- add RB tag from Dmitry
- Link to v1: https://lore.kernel.org/r/20241021-alpha-mode-cleanup-v1-5-55df8ed73645@gmail.com
---
drivers/clk/qcom/dispcc-sm6115.c | 2 --
1 file changed, 2 deletions(-)
diff --git a/drivers/clk/qcom/dispcc-sm6115.c b/drivers/clk/qcom/dispcc-sm6115.c
index 939887f82ecc3da21a5f26168c3161aa8cfeb3cb..2b236d52b29fe72b8979da85c8bd4bfd1db54c0b 100644
--- a/drivers/clk/qcom/dispcc-sm6115.c
+++ b/drivers/clk/qcom/dispcc-sm6115.c
@@ -48,8 +48,6 @@ static const struct pll_vco spark_vco[] = {
/* 768MHz configuration */
static const struct alpha_pll_config disp_cc_pll0_config = {
.l = 0x28,
- .alpha = 0x0,
- .alpha_en_mask = BIT(24),
.vco_val = 0x2 << 20,
.vco_mask = GENMASK(21, 20),
.main_output_mask = BIT(0),
--
2.47.0