Hi Manorit
On 23/10/24 12:27, Manorit Chawdhry wrote:
> Adds bootph-* properties to the leaf nodes to enable bootloaders to
> utilise them.
>
> Following adds bootph-* to
> - System controller nodes that allow controlling power domain, clocks, etc.
> - secure_proxy_sa3/secure_proxy_main mboxes for communication with
> System Controller
> - mcu_ringacc/mcu_udmap for DMA to SMS
> - chipid for detection soc information.
> - mcu_timer0 for bootloader tick-timer.
> - hbmc_mux for enabling Hyperflash support
> - ESM nodes for enabling ESM support.
> - wkup_vtm for enabling Adaptive voltage scaling(AVS) support
>
> Signed-off-by: Manorit Chawdhry <m-chawdhry@ti.com>
> ---
> arch/arm64/boot/dts/ti/k3-j721e-main.dtsi | 2 ++
> arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi | 10 ++++++++++
> 2 files changed, 12 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> index 0da785be80ff..af3d730154ac 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
> @@ -226,6 +226,7 @@ secure_proxy_main: mailbox@32c00000 {
> <0x00 0x32800000 0x00 0x100000>;
> interrupt-names = "rx_011";
> interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
> + bootph-all;
> };
>
> smmu0: iommu@36600000 {
> @@ -2853,6 +2854,7 @@ main_spi7: spi@2170000 {
> main_esm: esm@700000 {
> compatible = "ti,j721e-esm";
> reg = <0x0 0x700000 0x0 0x1000>;
> + bootph-pre-ram;
> ti,esm-pins = <344>, <345>;
> };
> };
> diff --git a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
> index 3731ffb4a5c9..cf5fb1160ada 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
> @@ -21,16 +21,19 @@ dmsc: system-controller@44083000 {
> k3_pds: power-controller {
> compatible = "ti,sci-pm-domain";
> #power-domain-cells = <2>;
> + bootph-all;
> };
>
> k3_clks: clock-controller {
> compatible = "ti,k2g-sci-clk";
> #clock-cells = <2>;
> + bootph-all;
> };
>
> k3_reset: reset-controller {
> compatible = "ti,sci-reset";
> #reset-cells = <2>;
> + bootph-all;
> };
> };
>
> @@ -61,6 +64,7 @@ wkup_conf: bus@43000000 {
> chipid: chipid@14 {
> compatible = "ti,am654-chipid";
> reg = <0x14 0x4>;
> + bootph-all;
> };
> };
>
> @@ -112,6 +116,7 @@ mcu_timer0: timer@40400000 {
> assigned-clocks = <&k3_clks 35 1>;
> assigned-clock-parents = <&k3_clks 35 2>;
> power-domains = <&k3_pds 35 TI_SCI_PD_EXCLUSIVE>;
> + bootph-pre-ram;
> ti,timer-pwm;
> /* Non-MPU Firmware usage */
> status = "reserved";
> @@ -362,6 +367,7 @@ hbmc_mux: mux-controller@47000004 {
> reg = <0x00 0x47000004 0x00 0x4>;
> #mux-control-cells = <1>;
> mux-reg-masks = <0x0 0x2>; /* HBMC select */
> + bootph-all;
> };
>
> hbmc: hyperbus@47034000 {
> @@ -470,6 +476,7 @@ mcu_ringacc: ringacc@2b800000 {
> <0x0 0x2a500000 0x0 0x40000>,
> <0x0 0x28440000 0x0 0x40000>;
> reg-names = "rt", "fifos", "proxy_gcfg", "proxy_target", "cfg";
> + bootph-all;
> ti,num-rings = <286>;
> ti,sci-rm-range-gp-rings = <0x1>; /* GP ring range */
> ti,sci = <&dmsc>;
> @@ -489,6 +496,7 @@ mcu_udmap: dma-controller@285c0000 {
> "tchan", "rchan", "rflow";
> msi-parent = <&main_udmass_inta>;
> #dma-cells = <1>;
> + bootph-all;
>
> ti,sci = <&dmsc>;
> ti,sci-dev-id = <236>;
> @@ -509,6 +517,7 @@ secure_proxy_mcu: mailbox@2a480000 {
> reg = <0x0 0x2a480000 0x0 0x80000>,
> <0x0 0x2a380000 0x0 0x80000>,
> <0x0 0x2a400000 0x0 0x80000>;
> + bootph-pre-ram;
> /*
> * Marked Disabled:
> * Node is incomplete as it is meant for bootloaders and
> @@ -687,6 +696,7 @@ wkup_vtm0: temperature-sensor@42040000 {
> <0x00 0x43000300 0x00 0x10>;
> power-domains = <&k3_pds 154 TI_SCI_PD_EXCLUSIVE>;
> #thermal-sensor-cells = <1>;
> + bootph-pre-ram;
> };
>
> mcu_esm: esm@40800000 {
>
Reviewed-by: Neha Malcom Francis <n-francis@ti.com>
--
Thanking You
Neha Malcom Francis