Replace deprecated snps,reset props and move them to the PHY node.

Fixes: 50decd493c83 ("arm64: dts: rockchip: Add FriendlyARM NanoPi R3S board")
Suggested-by: Jonas Karlman <jonas@kwiboo.se>
Signed-off-by: Tianling Shen <cnsztl@gmail.com>
---
 arch/arm64/boot/dts/rockchip/rk3566-nanopi-r3s.dts | 7 +++----
 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3566-nanopi-r3s.dts b/arch/arm64/boot/dts/rockchip/rk3566-nanopi-r3s.dts
index 6bc17f755b79..66a00cddda0c 100644
--- a/arch/arm64/boot/dts/rockchip/rk3566-nanopi-r3s.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3566-nanopi-r3s.dts
@@ -149,10 +149,6 @@ &gmac1m0_tx_bus2_level3
 		     &gmac1m0_rx_bus2
 		     &gmac1m0_rgmii_clk_level2
 		     &gmac1m0_rgmii_bus_level3>;
-	snps,reset-gpio = <&gpio4 RK_PC2 GPIO_ACTIVE_LOW>;
-	snps,reset-active-low;
-	/* Reset time is 20ms, 100ms for rtl8211f */
-	snps,reset-delays-us = <0 20000 100000>;
 	status = "okay";
 };
 
@@ -414,6 +410,9 @@ rgmii_phy1: ethernet-phy@1 {
 		interrupts = <RK_PC3 IRQ_TYPE_LEVEL_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&eth_phy_reset_pin>;
+		reset-assert-us = <20000>;
+		reset-deassert-us = <100000>;
+		reset-gpios = <&gpio4 RK_PC2 GPIO_ACTIVE_LOW>;
 	};
 };
 
-- 
2.47.0