On 10/11/2024 1:16 PM, Krishna Kurapati wrote:
> This series aims at enabling USB on QCS8300 which has 2 USB controllers.
> The primary controller is SuperSpeed capable and secondary one is
> High Speed only capable. Both the High Speed Phys are Femto phys and the
> SuperSpeed Phy is a QMP Uni Phy.
>
> Base DT Support has been added for both controllers while only one has
> been enabled on Ride Platform. The primary controller has been configured
> in device mode. The secondary controller will be enabled in host mode post
> addition of SPMI Node which allows control over PMIC Gpios for providing
> vbus to connected peripherals.
>
> This series depends on the following series ACKed by upstream maintainers:
> Base DT: https://lore.kernel.org/all/20240925-qcs8300_initial_dtsi-v2-0-494c40fa2a42@quicinc.com/
>
> Bindings patches posted at:
> https://lore.kernel.org/all/20241009195348.2649368-1-quic_kriskura@quicinc.com/
>
> DTBS Check has been done on the patches.
>
Gentle ping for review.
Regards,
Krishna,
> Link to v1:
> https://lore.kernel.org/all/20241009195636.2649952-1-quic_kriskura@quicinc.com/
>
> Changes in v2:
> Added quirk to use pipe clk as utmi clk for second controller.
> Added wakeup source for second controller.
> Modified commit text for DTS change.
>
> Krishna Kurapati (2):
> arm64: dts: qcom: Add support for usb nodes on QCS8300
> arm64: dts: qcom: Enable USB controllers for QCS8300
>
> arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 23 +++
> arch/arm64/boot/dts/qcom/qcs8300.dtsi | 168 ++++++++++++++++++++++
> 2 files changed, 191 insertions(+)
>