Add the node describing uart18 for sc8280xp devices.

Signed-off-by: Jérôme de Bretagne <jerome.debretagne@gmail.com>
---
 arch/arm64/boot/dts/qcom/sc8280xp.dtsi | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
index 14c3b1d6ad47..e068de274b56 100644
--- a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
@@ -1013,6 +1013,20 @@ spi18: spi@888000 {
 				status = "disabled";
 			};
 
+			uart18: serial@888000 {
+				compatible = "qcom,geni-uart";
+				reg = <0 0x00888000 0 0x4000>;
+				clocks = <&gcc GCC_QUPV3_WRAP2_S1_CLK>;
+				clock-names = "se";
+				interrupts = <GIC_SPI 584 IRQ_TYPE_LEVEL_HIGH>;
+				operating-points-v2 = <&qup_opp_table_100mhz>;
+				power-domains = <&rpmhpd SC8280XP_CX>;
+				interconnects = <&clk_virt MASTER_QUP_CORE_2 0 &clk_virt SLAVE_QUP_CORE_2 0>,
+						<&gem_noc MASTER_APPSS_PROC 0 &config_noc SLAVE_QUP_2 0>;
+				interconnect-names = "qup-core", "qup-config";
+				status = "disabled";
+			};
+
 			i2c19: i2c@88c000 {
 				compatible = "qcom,geni-i2c";
 				reg = <0 0x0088c000 0 0x4000>;
-- 
2.45.2

On 4.09.2024 12:42 AM, Jérôme de Bretagne wrote:
> Add the node describing uart18 for sc8280xp devices.
> 
> Signed-off-by: Jérôme de Bretagne <jerome.debretagne@gmail.com>
> ---
>  arch/arm64/boot/dts/qcom/sc8280xp.dtsi | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> index 14c3b1d6ad47..e068de274b56 100644
> --- a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
> @@ -1013,6 +1013,20 @@ spi18: spi@888000 {
>  				status = "disabled";
>  			};
>  
> +			uart18: serial@888000 {
> +				compatible = "qcom,geni-uart";
> +				reg = <0 0x00888000 0 0x4000>;
> +				clocks = <&gcc GCC_QUPV3_WRAP2_S1_CLK>;

This should be the _S2 clock

Konrad