This patch series adds USB3/PCIE COMBOPHY driver for the STM32MP25 SoC from
STMicrolectronics, respective yaml schema and enable for the stm32mp257f-ev1
device into which it is used for PCIe.

Changes in v3:
Address comments from Rob and Krzysztof:
   - Reorder MAINTAINERS patch
   - Drop wakeup-source from bindings (should be generic)

Changes in v2:
   - Reorder entries
   - Rename clock_names and reset_names bindings
   - Rename and clarify rx-equalizer binding 

Christian Bruel (5):
  dt-bindings: phy: Add STM32MP25 COMBOPHY bindings
  phy: stm32: Add support for STM32MP25 COMBOPHY.
  MAINTAINERS: add entry for ST STM32MP25 COMBOPHY driver
  arm64: dts: st: Add combophy node on stm32mp251
  arm64: dts: st: Enable COMBOPHY on the stm32mp257f-ev1 board

 .../bindings/phy/st,stm32-combophy.yaml       | 144 +++++
 MAINTAINERS                                   |   6 +
 arch/arm64/boot/dts/st/stm32mp251.dtsi        |  17 +
 arch/arm64/boot/dts/st/stm32mp257f-ev1.dts    |  14 +
 drivers/phy/st/Kconfig                        |  11 +
 drivers/phy/st/Makefile                       |   1 +
 drivers/phy/st/phy-stm32-combophy.c           | 607 ++++++++++++++++++
 7 files changed, 800 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/st,stm32-combophy.yaml
 create mode 100644 drivers/phy/st/phy-stm32-combophy.c

-- 
2.34.1

On 27/08/2024 14:24, Christian Bruel wrote:
> This patch series adds USB3/PCIE COMBOPHY driver for the STM32MP25 SoC from
> STMicrolectronics, respective yaml schema and enable for the stm32mp257f-ev1
> device into which it is used for PCIe.
> 
> Changes in v3:
> Address comments from Rob and Krzysztof:
>    - Reorder MAINTAINERS patch
>    - Drop wakeup-source from bindings (should be generic)

Where? Point me to the exact line being dropped.

Best regards,
Krzysztof