From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
When the PHY is first coming up (or resuming from suspend), it's
possible that although the FW status shows as running, we still see
zeroes in the GLOBAL_CFG set of registers and cannot determine available
modes. Since all models support 10M, add a poll and wait the config to
become available.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
---
drivers/net/phy/aquantia/aquantia_main.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/net/phy/aquantia/aquantia_main.c b/drivers/net/phy/aquantia/aquantia_main.c
index 974795bd0860..2c8ba2725a91 100644
--- a/drivers/net/phy/aquantia/aquantia_main.c
+++ b/drivers/net/phy/aquantia/aquantia_main.c
@@ -652,7 +652,13 @@ static int aqr107_fill_interface_modes(struct phy_device *phydev)
unsigned long *possible = phydev->possible_interfaces;
unsigned int serdes_mode, rate_adapt;
phy_interface_t interface;
- int i, val;
+ int i, val, ret;
+
+ ret = phy_read_mmd_poll_timeout(phydev, MDIO_MMD_VEND1,
+ VEND1_GLOBAL_CFG_10M, val, val != 0,
+ 1000, 100000, false);
+ if (ret)
+ return ret;
/* Walk the media-speed configuration registers to determine which
* host-side serdes modes may be used by the PHY depending on the
--
2.43.0