> On 11 Jun 2024, at 7:50 PM, Jonas Karlman <jonas@kwiboo.se> wrote:
>
> This series ensure poweron/poweroff and CEC phys addr invalidation is
> happening under drm mode_config mutex lock, and also ensure EDID is
> updated (when the dw-hdmi connector is used) after a hotplug pulse.
>
> These changes has mainly been tested on Rockchip devices together with a
> forthcoming series that add HDMI 2.0 4K@60Hz support to RK3228, RK3328,
> RK3399 and RK3568.
>
> Rockchip use the dw-hdmi connector so this should also be validated with
> a driver that use the bridge connector.
I’m not sure my level of kernel fiddling counts as proper validation
(Neil would be a more authoritative tester) but FWIW, I picked the
series to my 6.10-rc4 dev branch (for Amlogic devices supported by the
LibreELEC distro) and AFAICT everything is still working. Tested with
Amlogic GXBB, GXL and G12B boards.
Tested-by: Christian Hewitt <christianshewitt@gmail.com>
> Jonas Karlman (8):
> drm: bridge: dw_hdmi: Call poweron/poweroff from atomic enable/disable
> drm: bridge: dw_hdmi: Use passed mode instead of stored previous_mode
> drm: bridge: dw_hdmi: Fold poweron and setup functions
> drm: bridge: dw_hdmi: Remove previous_mode and mode_set
> drm: bridge: dw_hdmi: Invalidate CEC phys addr from connector detect
> drm: bridge: dw_hdmi: Remove cec_notifier_mutex
> drm: bridge: dw_hdmi: Update EDID during hotplug processing
> drm: bridge: dw_hdmi: Use display_info is_hdmi and has_audio
>
> drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 145 ++++++----------------
> 1 file changed, 39 insertions(+), 106 deletions(-)