On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 arch/arm/boot/dts/qcom/qcom-sdx55.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi b/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi
index 2045fc779f88..053dac097c70 100644
--- a/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi
+++ b/arch/arm/boot/dts/qcom/qcom-sdx55.dtsi
@@ -378,6 +378,16 @@ pcie_rc: pcie@1c00000 {
 			phy-names = "pciephy";
 
 			status = "disabled";
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie_ep: pcie-ep@1c00000 {

-- 
2.25.1