Reformat the comments to utilize the maximum line length and use single
line comments where appropriate. Remove superfluous comments, too.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Acked-by: Lee Jones <lee@kernel.org>
---
include/linux/mfd/tmio.h | 32 +++++++++++---------------------
1 file changed, 11 insertions(+), 21 deletions(-)
diff --git a/include/linux/mfd/tmio.h b/include/linux/mfd/tmio.h
index f71d4e507dcb..1cf418643da9 100644
--- a/include/linux/mfd/tmio.h
+++ b/include/linux/mfd/tmio.h
@@ -5,23 +5,23 @@
#include <linux/platform_device.h>
#include <linux/types.h>
-/* tmio MMC platform flags */
+/* TMIO MMC platform flags */
+
/*
- * Some controllers can support a 2-byte block size when the bus width
- * is configured in 4-bit mode.
+ * Some controllers can support a 2-byte block size when the bus width is
+ * configured in 4-bit mode.
*/
#define TMIO_MMC_BLKSZ_2BYTES BIT(1)
-/*
- * Some controllers can support SDIO IRQ signalling.
- */
+
+/* Some controllers can support SDIO IRQ signalling */
#define TMIO_MMC_SDIO_IRQ BIT(2)
/* Some features are only available or tested on R-Car Gen2 or later */
#define TMIO_MMC_MIN_RCAR2 BIT(3)
/*
- * Some controllers require waiting for the SD bus to become
- * idle before writing to some registers.
+ * Some controllers require waiting for the SD bus to become idle before
+ * writing to some registers.
*/
#define TMIO_MMC_HAS_IDLE_WAIT BIT(4)
@@ -32,31 +32,21 @@
*/
#define TMIO_MMC_USE_BUSY_TIMEOUT BIT(5)
-/*
- * Some controllers have CMD12 automatically
- * issue/non-issue register
- */
+/* Some controllers have CMD12 automatically issue/non-issue register */
#define TMIO_MMC_HAVE_CMD12_CTRL BIT(7)
/* Controller has some SDIO status bits which must be 1 */
#define TMIO_MMC_SDIO_STATUS_SETBITS BIT(8)
-/*
- * Some controllers have a 32-bit wide data port register
- */
+/* Some controllers have a 32-bit wide data port register */
#define TMIO_MMC_32BIT_DATA_PORT BIT(9)
-/*
- * Some controllers allows to set SDx actual clock
- */
+/* Some controllers allows to set SDx actual clock */
#define TMIO_MMC_CLK_ACTUAL BIT(10)
/* Some controllers have a CBSY bit */
#define TMIO_MMC_HAVE_CBSY BIT(11)
-/*
- * data for the MMC controller
- */
struct tmio_mmc_data {
void *chan_priv_tx;
void *chan_priv_rx;
--
2.43.0