Move interrupt configuration from mv88q222x_revb0_config_init to
mv88q2xxx_config_init. Same register and bits are used for the 88q2xxx
devices.

Signed-off-by: Dimitri Fedrau <dima.fedrau@gmail.com>
---
 drivers/net/phy/marvell-88q2xxx.c | 16 ++++++++--------
 1 file changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/net/phy/marvell-88q2xxx.c b/drivers/net/phy/marvell-88q2xxx.c
index 7afaa693316f..dc0f150826f0 100644
--- a/drivers/net/phy/marvell-88q2xxx.c
+++ b/drivers/net/phy/marvell-88q2xxx.c
@@ -375,6 +375,14 @@ static int mv88q2xxx_config_init(struct phy_device *phydev)
 	 */
 	phydev->pma_extable = MDIO_PMA_EXTABLE_BT1;
 
+	/* Configure interrupt with default settings, output is driven low for
+	 * active interrupt and high for inactive.
+	 */
+	if (phy_interrupt_is_valid(phydev))
+		return phy_set_bits_mmd(phydev, MDIO_MMD_PCS,
+					MDIO_MMD_PCS_MV_GPIO_INT_CTRL,
+					MDIO_MMD_PCS_MV_GPIO_INT_CTRL_TRI_DIS);
+
 	return 0;
 }
 
@@ -700,14 +708,6 @@ static int mv88q222x_revb0_config_init(struct phy_device *phydev)
 			return ret;
 	}
 
-	/* Configure interrupt with default settings, output is driven low for
-	 * active interrupt and high for inactive.
-	 */
-	if (phy_interrupt_is_valid(phydev))
-		return phy_set_bits_mmd(phydev, MDIO_MMD_PCS,
-					MDIO_MMD_PCS_MV_GPIO_INT_CTRL,
-					MDIO_MMD_PCS_MV_GPIO_INT_CTRL_TRI_DIS);
-
 	return mv88q2xxx_config_init(phydev);
 }
 
-- 
2.39.2

On Tue, Feb 13, 2024 at 10:39:53PM +0100, Dimitri Fedrau wrote:
> Move interrupt configuration from mv88q222x_revb0_config_init to
> mv88q2xxx_config_init. Same register and bits are used for the 88q2xxx
> devices.
> 
> Signed-off-by: Dimitri Fedrau <dima.fedrau@gmail.com>

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew

On Tue, Feb 13, 2024 at 10:39:53PM +0100, Dimitri Fedrau wrote:
> Move interrupt configuration from mv88q222x_revb0_config_init to
> mv88q2xxx_config_init. Same register and bits are used for the 88q2xxx
> devices.
> 
> Signed-off-by: Dimitri Fedrau <dima.fedrau@gmail.com>

I couldn't test it because we don't have the interrupt pin connected but
according to datasheet of the 88Q2110 it looks good.

Reviewed-by: Stefan Eichenberger <eichest@gmail.com>