There are two points with the calculation of RX buffer size which are
not optimal:
1. mtu is a mutual parameter, but actually we need the maximum possible
MTU. So better use the define directly.
2. This magic number 4 represent the hardware generated frame length
which is specific to SPI. We better replace this with the suitable
define.
There is no functional change.
Signed-off-by: Stefan Wahren <wahrenst@gmx.net>
---
drivers/net/ethernet/qualcomm/qca_spi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/qualcomm/qca_spi.c b/drivers/net/ethernet/qualcomm/qca_spi.c
index 450c3d254075..50a862a85f1a 100644
--- a/drivers/net/ethernet/qualcomm/qca_spi.c
+++ b/drivers/net/ethernet/qualcomm/qca_spi.c
@@ -795,8 +795,8 @@ qcaspi_netdev_init(struct net_device *dev)
qca->clkspeed = qcaspi_clkspeed;
qca->burst_len = qcaspi_burst_len;
qca->spi_thread = NULL;
- qca->buffer_size = (dev->mtu + VLAN_ETH_HLEN + QCAFRM_HEADER_LEN +
- QCAFRM_FOOTER_LEN + 4) * QCASPI_RX_MAX_FRAMES;
+ qca->buffer_size = (QCAFRM_MAX_MTU + VLAN_ETH_HLEN + QCAFRM_HEADER_LEN +
+ QCAFRM_FOOTER_LEN + QCASPI_HW_PKT_LEN) * QCASPI_RX_MAX_FRAMES;
memset(&qca->stats, 0, sizeof(struct qcaspi_stats));
--
2.34.1